Reel Speed-Change Pulley Assembly (150 mm) for FM WORLD 4LZ-6.0P
This stepped pulley lets the operator change the reel speed by moving the belt between its grooves. Measuring 150 mm in diameter on a 22 mm shaft and 40 mm wide, 1.6 kg, it sits on the header reel drive.
Stepped pulley dimensions
| Part number | W2.5E-01XCP-01-04A-01-00 |
| Part type | Speed-change pulley assembly |
| Outer diameter | 150 mm |
| Bore | 22 mm |
| Body height | 40 mm |
| Weight | 1.6 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
How the reel speed is changed
Shifting the belt from one groove to the other changes the effective ratio and so the reel speed, letting the sweep match light or heavy crop without changing the engine drive.
Reading the two grooves
The 150 mm diameter and 22 mm bore identify this speed pulley and distinguish it from the 280 mm single-groove drive pulley. Each step must match the belt section or the belt will not seat.
Fitting the speed pulley
Align the key and seat the pulley on the shaft, then check both grooves run true. Confirm the belt moves cleanly between steps and sits flush in the chosen groove before running.
After selecting a speed, re-check the belt tension and the alignment with the mating pulley so the belt does not rub on a step edge.
Replacement signs
- One groove worn or cupped so the belt slips in that speed
- A loose bore or damaged keyway causing runout
- Chipped step edges that catch the belt
- Belt wander or squeal in a particular ratio
- Corrosion that narrows a groove
- Stiff or hesitant speed changes
Ordering details
Mounting: Stepped speed-change pulley on the header reel of FM WORLD 4LZ-6.0P (Ruilong) machines.
Confirmation: Send us the part number together with the 150 mm and 22 mm measurements and we check the stepped pulley matches.
Dimensions to match: Check the diameter, bore, both groove sections and the body height against your old pulley.
Reel drive and tension parts
Buyer questions
Can I run the belt in either groove right away?
Yes, that is the purpose of the stepped pulley, but confirm the belt is fully seated and the tension is reset after each change.
Why does one speed slip but not the other?
Usually one groove is worn or cupped while the other is still sound; inspect the slipping step for polishing or a widened profile.
Identification of W2.5E-01XCP-01-04A-01-00 before ordering
Fit this speed-change pulley when a groove is worn or the bore is loose; if both steps still seat the belt and run true, it does not need replacing.





