Knife Section W2.0-01-01-03G-03-05 — 85 x 75 x 1.8 mm
This is a single hardened knife section that bolts onto the moving sickle of the FM WORLD 4LZ-6.0P cutter bar. At 85 x 75 mm and only 1.8 mm thick it is one of the serrated blades that travels back and forth against the fixed ledger plate, forming the scissors cut. One broken or blunt section can be replaced on its own without changing the whole bar.
Specifications
| Part number | W2.0-01-01-03G-03-05 |
|---|---|
| Type | Single reciprocating knife section |
| Length x width x thickness | 85 x 75 x 1.8 mm |
| Weight | 0.07 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
The section does the actual cutting. Its sharpened, serrated edge moves across the fixed ledger plate thousands of times per minute, so the steel is hardened to hold an edge and resist impact from stones. Because every section cuts the same way, one damaged blade leaves a strip of torn or uncut stalks across the header.
A single section against the complete cutter bar assembly
This 2315 part is one 0.07 kg blade for a single position, whereas the 2345 and 2311 assemblies are the full frames carrying 31 or 29 sections. Replace an individual section when only one is cracked or worn; use a complete assembly only when the frame itself is bent or multiple positions are damaged.
Fitting notes
Remove the damaged section and clean its mounting face so the new blade sits flat, then secure it and confirm it lines up with the neighbouring sections. Once fitted, the sickle should be turned by hand to check the section rests on its ledger plate through the full stroke. Keep the knife register and any lubrication to the service manual rather than forcing the blade down.
Before you fit it
Inspect the ledger plate and guard behind the damaged section, since a worn guard can break a new blade even when the section itself is at fault.
Signs it needs replacing
- A cracked section or a missing tooth
- A blunt or rounded cutting edge leaving torn stalks
- A bent section that catches the guard on each stroke
- One position cutting poorly while the rest of the bar still cuts clean
Compatibility and cross reference
Models covered
Listed for the FM WORLD 4LZ-6.0P Ruilong cutter bar; match the position and the part number on the old section.
Confirming the right part
Measure the old section at 85 x 75 mm and match W2.0-01-01-03G-03-05 before ordering.
Reading the old part
85 x 75 x 1.8 mm and 0.07 kg — thin enough that a section worn at the edge looks almost like a new one. Compare the cutting edge against a new section on a flat surface; the 1.8 mm thickness is what tells a worn section from a distorted one.
Questions we are asked about this part
Can I replace just one knife section?
Yes. If the bar is straight and only one section is damaged, fit a new section on that position and re-check the register against the guard.





