,

Cutter Bar Assy,Blade Fixed (W3.5D-01D-01-03-03-00)

complete cutter bar assembly with fixed knife, 2.36 m header. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Cutter Bar Assembly W3.5D-01D-01-03-03-00 — 2.36 m, 31 Sections

This is the complete reciprocating cutter bar for the 2.36 m header on the FM WORLD 4LZ-6.0P Ruilong. The 2500 mm frame carries 31 knife sections that move as one sickle against the fixed ledger plates, so the unit arrives ready to restore the full cutting geometry rather than one worn position. At 6.5 kg it is built for the wider header, not the 2.2 m platform.

Specifications

Part numberW3.5D-01D-01-03-03-00
TypeComplete cutter bar assembly with fixed knife
Overall dimensions2500 x 860 x 49 mm
Knife sections31
Weight6.5 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

The assembly is the frame the guards, guides and moving sickle all register to. On a header this wide, every section has to stop centred on its guard or the load becomes uneven and the crop tears instead of shearing. Fitting a complete unit brings the bar back to one straight reference, which bolting new sections onto a bent frame cannot do.

The 2.36 m 31-section bar against the 2.2 m 29-section bar

This 2345 bar is built for the 2.36 m header with 31 sections and a 2500 mm frame, while the 2311 assembly serves the 2.2 m header with 29 sections at 2350 mm. The two are not interchangeable: header width decides the part, and the section count and mounting positions will not match if the wrong bar is ordered.

Fitting notes

Mount the assembly on a clean, flat header face and bolt it square before the knife head and drive are connected. Turn the sickle through its full travel by hand to confirm it runs free and that each section registers centred on its guard, then set the guards and hold-downs to the new bar rather than reusing the old settings. The service manual gives the correct register and lubrication schedule for this machine.

Before you fit it

Check the header mounting face is flat and free of worn or broken seats before the new bar goes on, so the frame can locate square.

Signs it needs replacing

  • The frame bent or twisted so the sections cannot register
  • Knife binding or uneven cutting across the full 2.36 m width
  • Several guard or guide positions worn into the frame itself
  • A repaired frame that no longer holds the cutting geometry

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong with the 2.36 m header; confirm the header width and the part number before ordering.

Confirming the right part

Match the number W3.5D-01D-01-03-03-00 and count 31 sections. A 29-section reading identifies the 2311 bar for the narrower header.

Reading the old part

2500 x 860 x 49 mm, 31 sections, 6.5 kg. The 860 mm figure is the one most often misread as a bar width, so measure the cutting length at 2500 mm and the section count at 31 before comparing it with the 29-section bar.

Questions we are asked about this part

Does this assembly include the moving knife sections?

Yes. It is supplied as a complete cutter bar with the 31 sections, so the full cutting unit can be fitted and registered to the header as one part.

Related parts