,

Blade Guide C (W2.0-01-01-03G-05)

cutter bar blade guide (knife hold-down), type C. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Blade Guide C W2.0-01-01-03G-05 — 172 x 155 x 40 mm

This is the type C blade guide that holds the moving sickle down and in line on the FM WORLD 4LZ-6.0P cutter bar. Its recess forms a track the knife back travels through, and the hold-down face keeps the sections pressed onto the ledger plates for a clean shearing cut. It is a locating casting rather than a sharpened part.

Specifications

Part numberW2.0-01-01-03G-05
TypeCutter bar blade guide (knife hold-down), type C
Length x width x height172 x 155 x 40 mm
Weight1 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

The guide controls the knife from the top and side while the friction plates support it from below. The recess has to stay accurate, because a worn or elongated track lets the sickle wander and lift off the ledger plates, which shows up as knife chatter and torn crop. A rigid guide keeps every section in the cutting position.

Guide C against the type B guide on the same cutter bar

This 2314 guide is the type C position at 172 x 155 mm and 1 kg, while the 2313 guide is the type B casting. The two bolt to different positions on the bar and are not interchangeable; fit the guide that matches the position rather than swapping the types.

Fitting notes

Clean the mounting face and the guide recess so the knife back moves through without binding, then bolt the guide down square. Do not over-tighten it to force the knife lower, since the guide is a locating part and the correct height comes from the register of the guards and wear plates. Confirm the correct clearance against the service manual.

Before you fit it

Check the knife back that runs through the recess is not itself worn, since a grooved back will keep binding even with a new guide.

Signs it needs replacing

  • The guide recess worn or elongated so the knife can wander
  • Cracking through the casting around the bolt lugs
  • Rough or fretted contact faces that make the sickle bind
  • Knife chatter that remains after the sections are renewed

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong cutter bar at the type C position; confirm the position and part number.

Confirming the right part

Match the number W2.0-01-01-03G-05 and the 172 x 155 mm dimensions; the type B position takes the 2313 guide instead.

Reading the old part

Guide C is the larger of the two hold-downs at 172 x 155 x 40 mm and 1 kg, against guide B at 155 x 105 x 40 mm. Both bolt to the same bar, so the quickest check is the 155 mm width, which only this guide has.

Questions we are asked about this part

Will a worn guide make the knife cut badly?

Yes. A worn recess lets the sections lift off the ledger plates, so renewing the guide restores the hold-down before the blades are replaced.

Related parts