,

Bar,Blade Fixed (W2.0B-01B-01-03G-02)

fixed knife bar (knife back beam), 6.0P. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Fixed Knife Bar W2.0B-01B-01-03G-02 — 2405 x 40 x 40 mm

This is the fixed knife bar for the FM WORLD 4LZ-6.0P cutter bar, a 2405 mm steel beam at 6.6 kg. It does not cut itself; it is the rigid reference the moving sickle and the wear surfaces align to. Keeping this beam straight is what holds the cutting register consistent along the full header.

Specifications

Part numberW2.0B-01B-01-03G-02
TypeFixed knife bar (knife back beam)
Length x section2405 x 40 x 40 mm
Weight6.6 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

The beam is the structural reference every cutting part mounts against. Once it bends, the sections no longer meet the ledger plates at the same height along its length, and no amount of guide or section adjustment corrects that uneven cut. A straight beam keeps the knife geometry true from one end of the header to the other.

The 6.0P 2405 mm beam against the 4.0E 2305 mm beam

This 2312 beam is 2405 mm and 6.6 kg for the 6.0P header, while the 1599 beam is 2305 mm and 6 kg for the 4.0E machine. They suit different header widths and are not interchangeable, so the beam length is the safest way to tell them apart.

Fitting notes

Mount the beam on clean, square seats and check it is straight before the sickle and guards are re-fitted. As a structural reference rather than a moving wear surface, its seats need to stay clean and flat so it locates accurately; the moving knife and its wear surfaces follow the service manual’s lubrication schedule.

Before you fit it

Inspect the mounting seats for wear before the beam goes back, since a worn seat stops the bar locating square.

Signs it needs replacing

  • The beam bent or twisted, giving uneven cutting along the header
  • Mounting faces worn or fretted so the bar cannot locate square
  • Sections failing to hold register across the full 2405 mm length
  • Cracking at a mounting point rather than a worn cutting edge

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong cutter bar; confirm the header width and part number.

Confirming the right part

Measure the old beam at 2405 mm and match W2.0B-01B-01-03G-02; a 2305 mm reading identifies the 4.0E beam.

Reading the old part

2405 mm long, 40 x 40 mm section, 6.6 kg. It sits between the 2305 mm and 2550 mm bars, a difference of 50 to 145 mm — enough to matter and small enough to be missed by eye, which is why the tape goes on before the order does.

Questions we are asked about this part

Do I replace this beam when the blades are blunt?

No. Blunt blades are renewed separately. The beam is only replaced when it is bent, twisted or worn at the mounting seats so the knife can no longer register.

Related parts