,

Blade Guide B (W2.0-01-01-03G-04)

blade guide (knife hold-down). In-stock replacement for the FM WORLD header. Order by part number; contact us for exact fitment.

Blade Guide B W2.0-01-01-03G-04 — 155 x 105 x 40 mm

The blade guide is a substantial cast holder that keeps the knife running true on the FM WORLD 4LZ-6.0P Ruilong header. At 155 x 105 x 40 mm and 0.55 kg it locates the knife laterally and holds the moving sections down against the guard ledger plates, so the knife travels in a straight line instead of lifting or wandering under load. It is a locating and hold-down part rather than a sharpened wear part.

Specifications

Part numberW2.0-01-01-03G-04
TypeBlade guide (knife hold-down)
Length x width x height155 x 105 x 40 mm
Weight0.55 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

Where the thin friction plates support the knife from below, the guide controls it from the side and the top: its recess forms a track the knife back moves through, and the hold-down face keeps the sections in the shearing position. The casting has to stay rigid and dimensionally accurate, because a loose or worn guide is what lets the knife chatter and tear the crop.

Blade guide versus the thin friction plates on the same knife drive

The guide is a 0.55 kg cast locator with a 40 mm section, while the friction plates are 2 mm hardened steel strips. They do different jobs: the guide locates and holds the knife down, the plates give it a surface to slide on. Replacing one does not remove the need to inspect the other, and the guide is never fitted where a flat wear plate is called for.

Fitting notes

Clean the mounting face and the guide recess so the knife back moves through without binding, then bolt the guide down squarely. Do not shim or over-tighten it to force the knife lower: the guide is a locating part, and the correct clearance is set by the register of the guards and wear plates, not by clamping the guide.

Before you fit it

Before the new guide goes on, run the knife back by hand and check the old recess for side play and fretting. A knife that moves freely without lateral slop tells you the guide may still be serviceable.

Signs it needs replacing

  • The guide recess worn or elongated so the knife can wander
  • Cracking through the casting around the bolt lugs
  • Rough or fretted contact faces that make the knife bind
  • Knife chatter and torn stalks that persist after the sections are renewed

Compatibility and cross reference

Models covered

Fits the FM WORLD 4LZ-6.0P Ruilong header; confirm the model and the 155 x 105 x 40 mm guide before ordering.

Confirming the right part

Match the number W2.0-01-01-03G-04 and verify the casting dimensions. This guide is specific to the Ruilong header and is not the same part as the 4.0E wear plates.

Reading the old part

Guide B measures 155 x 105 x 40 mm and weighs 0.55 kg; the C guide beside it is 172 x 155 x 40 mm and 1 kg. Both are knife hold-downs of the same family, so a wrong one will fit loosely and hold the knife unevenly instead of failing outright.

Questions we are asked about this part

If the knife is cutting ragged, is the guide always the cause?

No. Worn sections, dull guards and thin friction plates produce the same symptom. Check the cheap cutting parts first and only replace the guide if its recess is actually worn or cracked.

Related parts