,

Cutter Bar Assembly, Blade Fixed (W2.5E-01XC-01-03-03-00)

complete cutter bar assembly with fixed knife. In-stock replacement for the FM WORLD header. Order by part number; contact us for exact fitment.

Cutter Bar Assembly W2.5E-01XC-01-03-03-00 — 2275 mm cut

This is the complete cutting assembly for the FM WORLD 4LZ-4.0E header, a 2275 x 115 x 45 mm unit weighing 5.92 kg. It brings the knife, guards, hold-downs and wear surfaces together as one aligned cutting system. It is fitted when the bar frame itself is damaged or multiple components are worn beyond economical piece-by-piece repair, rather than as a routine seasonal change.

Specifications

Part numberW2.5E-01XC-01-03-03-00
TypeComplete cutter bar assembly, fixed knife
Cutting length2275 mm
Overall width x height115 x 45 mm
Weight5.92 kg
FitsFM WORLD 4LZ-4.0E Combine Harvester
AvailabilityIn stock, ready to ship

What this part does

The assembly is the structural frame every smaller cutting part mounts into. Because the guards and knife register to the frame, a bent or worn frame cannot be fixed by bolting on new sections. The complete unit restores the geometry and alignment that the individual wear parts depend on.

Full assembly versus replacing the individual wear parts

A new knife section or friction plate is a low-cost repair that solves a specific worn part. The full 5.92 kg assembly is only justified when the frame is bent, cracked or worn so that several parts cannot be re-registered. It is not the default choice for a dull knife, and the small parts should be assessed first.

Fitting notes

Mount the assembly on a clean, flat header face and bolt it square before connecting the knife head. Confirm the knife runs free through its full stroke and register the guards and hold-downs to the new bar rather than assuming the old settings carry over.

Before you fit it

Before ordering a full assembly, inspect the frame for a bend and price the individual worn parts, so the complete unit is chosen only when piece repair is not viable.

Signs it needs replacing

  • The bar frame bent, cracked or twisted so the knife cannot register
  • Multiple guard and guide positions worn in the frame itself
  • Knife binding or uneven cutting across the full width of the bar
  • A frame repair that no longer holds the cutting geometry

Compatibility and cross reference

Models covered

Fits the FM WORLD 4LZ-4.0E header at the 2275 mm cutting width; confirm the model and length before ordering.

Confirming the right part

Match the number W2.5E-01XC-01-03-03-00 and the 2275 mm length. This is a full assembly, not a single knife.

Reading the old part

Read a complete bar by cutting length, not by bolt count: 2275 mm cutting length, 115 x 45 mm overall, 5.92 kg. The assembly number is stamped on the bar, and on a bar that has been reconditioned it is often painted over, so measure before ordering.

Questions we are asked about this part

Is a complete assembly needed whenever the cut is poor?

No. Most poor cutting is fixed with sections, guards or wear plates. Use the full assembly only when the frame itself is damaged or the individual positions cannot be restored.

Related parts