Upper Cutter Swing Lever W2.0-01-01-07-01-02 — 160 x 135 x 60 mm
This lever is part of the knife drive on the FM WORLD 4LZ-4.0E. The 160 x 135 x 60 mm arm pivots on a 45 mm bore and converts the wobble-box motion into the back-and-forth stroke that drives the knife. It is a loaded linkage, so its pivot bore and connecting faces take continuous cyclic force rather than sliding wear.
Specifications
| Part number | W2.0-01-01-07-01-02 |
|---|---|
| Type | Upper cutter swing lever (knife drive arm) |
| Length x width x height | 160 x 135 x 60 mm |
| Pivot bore | 45 mm |
| Weight | 1.2 kg |
| Fits | FM WORLD 4LZ-4.0E Combine Harvester |
| Availability | In stock, ready to ship |
What this part does
The swing lever is a force-transmission part, not a cutting or scraping part. Each revolution loads and unloads the arm, so its service life depends on the pivot bore staying round and the arm remaining uncracked. A worn bore introduces slack into the knife stroke, which shows up as lost motion before the knife even moves.
Drive lever against the static guides and wear plates
The friction plates and blade guides are stationary parts the knife moves over; this lever is a moving part that supplies the stroke. It pivots on a 45 mm bore and weighs 1.2 kg, and it is replaced for pivot wear or cracking, never because its surface is abraded like a wear plate.
Fitting notes
Fit the lever on a clean, greased pivot and confirm it swings through its full arc without binding. The pivot bore needs lubrication to protect the pin, while the mounting faces stay clean and square; do not confuse the two, because the moving pivot is the one surface that must not run dry.
Before you fit it
Before fitting, inspect the pivot pin and any bushings for wear and confirm the wobble-box output is not the source of the slack.
Signs it needs replacing
- Pivot bore worn oval, producing slack in the knife stroke
- Cracking or deformation around the arm or its lugs
- Knife head moving less than its full travel despite a good drive belt
- Knocking from the drive that follows the knife stroke rate
Compatibility and cross reference
Models covered
Fits the FM WORLD 4LZ-4.0E knife drive; confirm the 45 mm pivot and part number before ordering.
Confirming the right part
Match the number W2.0-01-01-07-01-02 and the 45 mm bore. This is a drive lever, not a knife section or guide.
Reading the old part
The 45 mm pivot bore is the fit that decides whether this lever is still serviceable: 160 x 135 x 60 mm, 1.2 kg. A bore that has opened shows up as play at the knife end long before the lever looks worn, so gauge it rather than judging by the eye.
Questions we are asked about this part
There is play in the knife drive; should I change the lever first?
Check the pivot pin and its bushings before the lever itself. If the pin is worn, a new lever on the same pin will still be loose. Replace the lever when its own bore is oval or the arm is cracked.





