,

Belt Pulley Weld,Reel (W2.5E-01XCP-01-05-03-00)

Part W2.5E-01XCP-01-05-03-00. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Welded Reel Belt Pulley (280 mm) for FM WORLD 4LZ-6.0P

This welded pulley takes the drive belt and turns the header reel on the FM WORLD 4LZ-6.0P. It is 280 mm across with a 25 mm bore and a 32 mm rim, 3 kg, and sits on the reel drive line.

Pulley measurements

Part numberW2.5E-01XCP-01-05-03-00
Part typeWelded reel drive pulley
Outer diameter280 mm
Bore25 mm
Rim height32 mm
Weight3 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

How it drives the reel

The belt wraps the groove and converts the header drive into reel rotation, so the pulley sets the speed at which the tines sweep. A true-running groove keeps the belt seated across the whole rim.

Why the bore and groove matter

Match both the 280 mm outer diameter and the 25 mm bore, because a pulley of a different diameter changes the reel speed while a wrong bore will not seat on the shaft. The 32 mm rim gives the belt its full bearing width.

Fitting the pulley

Slide the pulley onto the shaft with the key aligned and seat it against the shoulder, then tighten the fixing without striking the rim. Spin it by hand to confirm it runs true before refitting the belt.

Re-tension the belt to the service-manual setting after fitting. Over-tensioning loads the shaft and bearings, while a loose belt slips and polishes the groove.

Replacement signs

  • A groove worn shiny or cupped from belt slip
  • Wobble or runout from a worn bore or keyway
  • A cracked weld or chipped rim edge
  • Belt squeal and slow reel pickup under load
  • Visible side-to-side movement on the shaft
  • Rust pitting that scores the belt

Ordering details

Mounting: Header reel drive on FM WORLD 4LZ-6.0P (Ruilong) combine harvesters.

Confirmation: Quote the part number and confirm the 280 mm diameter and 25 mm bore against your removed pulley.

Dimensions to match: Check the outer diameter, bore, rim height and the belt section of the groove before ordering.

Reel drive components

  • Part 2375
  • Part 2491
  • Buyer questions

    Does this pulley include the belt?

    No, it is the welded pulley only; order the reel belt separately to its own part number.

    How do I know the groove is worn?

    A cupped or polished groove that lets the belt slip or squeal under load, together with visible runout, points to replacement.

    Identification of W2.5E-01XCP-01-05-03-00 before ordering

    Fit this pulley only when the groove is worn from slip, the bore is loose or the weld is cracked; a true pulley with a clean groove can stay in service.

    Request a Quote Now