Swing Rod Shaft W2.5E-01D-01-07-02-05A (375 mm, 35/30 mm Diameters)
The W2.5E-01D-01-07-02-05A swing rod shaft is 375 mm long with 35 mm and 30 mm diameter sections, weighing 2.35 kg.
Swing rod pivot data
| Part number | W2.5E-01D-01-07-02-05A |
| Component | Swing rod shaft |
| Length | 375 mm |
| Diameters | 35 mm / 30 mm |
| Mass | 2.35 kg |
| Motion | Swing/oscillation |
Swing rod shaft role
The shaft acts as the pivot axis for the swing rod, allowing the linked part to oscillate while remaining supported.
Swing rod shaft differences
A sleeve protects a bore or shaft surface, whereas this swing rod shaft carries the pivot load itself.
Swing rod shaft installation
Clean the rod bore and check the two diameter sections before insertion. Install the shaft squarely and retain it before releasing the rod.
Move the swing rod through its full arc and check for play, tight spots or retainer contact.
Swing rod shaft wear checks
- Worn 35 mm section
- Scored 30 mm section
- Elongated rod bore
- Bent shaft
- Retainer groove damage
- Uneven oscillation
Swing rod shaft ordering checks
W2.5E swing rod linkage.
Reference W2.5E-01D-01-07-02-05A when ordering, then verify the 375 mm length, 35/30 mm diameters and 2.35 kg mass.
Match the stepped diameters, retainer feature and swing rod bore with the original shaft.
Swing rod shaft related parts
Swing rod shaft questions
Why are there two diameter values?
The shaft is stepped, and each section must match the rod and support geometry.
Should the sleeve be replaced at the same time?
That depends on inspection; the sleeve is a separate part.
Identification of W2.5E-01D-01-07-02-05A before ordering
Replace this shaft when the swing rod has excess play, binds during movement or shows wear on the stepped surfaces.




