Header Auger W2.5E-01D-01-02B-01-00 — 2200 mm, 52.4 kg
Built for the 2.2 m header, this 52.4 kg weldment is the narrower of the two large intake augers on the FM WORLD 4LZ-6.0P Ruilong, spanning 2200 mm by 500 mm with a 300 mm helix. Retractable fingers work alongside it to draw the cut swath inward and hand it to the centre conveyor. The 130 mm shorter tube is what separates it from the 2338 fitted to the wider header.
Specifications
| Part number | W2.5E-01D-01-02B-01-00 |
|---|---|
| Type | Header auger weld (2.2 m header) |
| Length x width | 2200 x 500 mm |
| Flight diameter | 300 mm |
| Weight | 52.4 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) Combine Harvester |
| Availability | In stock, ready to ship |
What this auger does
Over the shorter tube the auger still has to gather the full swath and drive it inward, so the helix and finger openings meet the same heavy stalk contact as the larger part. A bent or thinned edge shows up as uneven feeding across the 2.2 m width. Rather than relying on the common 300 mm helix, the 2200 mm length is the reliable way to identify this weldment.
The 2.2 m header auger against the 2.36 m header auger
Both use a 300 mm flight and 500 mm width, but this 2292 is 2200 mm and 52.4 kg for the 2.2 m header against the 2330 mm, 55 kg 2338 for the 2.36 m header. Header width decides the part; the two are not interchangeable.
Fitting notes
Place the weldment on clean, square seats and check the long tube runs true before the drive is coupled. Finger timing and clearance are set from the service manual, after which hand rotations across the width should show a steady gap and no contact. The mounts can then be locked and the bearings and fingers oiled per the manual.
Before you fit it
Check the retractable fingers, sliders and floor alongside the auger for the same feeding fault.
Signs it needs replacing
- Uneven crop gathering across the 2.2 m width
- Worn or bent 300 mm flight edges
- Finger timing faults causing bunching
- Bearing wear or a bent tube causing vibration
Compatibility and cross reference
Models covered
Fits the 2.2 m header of the FM WORLD 4LZ-6.0P Ruilong; check the 2200 mm tube and 300 mm helix before ordering.
Confirming the right part
Match W2.5E-01D-01-02B-01-00 and 2200 mm. A 2330 mm part is the 2.36 m header 2338.
Reading the old part
2200 x 500 mm with a 300 mm flight diameter and 52.4 kg. The flight diameter is the figure that separates the 2.2 m and 2.36 m header augers when the numbers are gone; both are 300 mm, so in that case measure the 2200 mm length instead.
Questions we are asked about this auger
Will the 300 mm header augers swap between headers?
No. They share the flight diameter but differ in length and header width, so match the 2200 mm part and number to the 2.2 m header rather than fitting on the 300 mm flight.





