Feeding Auger W2.5K-02S-02-02-00B-00 — Tapered, 18.8 kg
This is the tapered feeding auger that pulls crop from the header into the feeder house on the FM WORLD 4LZ-6.0P Ruilong. Unlike the straight horizontal augers, it is a narrowing cone — 485 mm across at the top, 460 mm at the lower end over a 600 mm width and 275 mm height — so it gathers a wide mat of material and compresses it into the narrower feeder opening. At 18.8 kg it is a heavy weldment built to take the full force of incoming crop.
Specifications
| Part number | W2.5K-02S-02-02-00B-00 |
|---|---|
| Type | Tapered feeding auger |
| Upper / lower diameter | 485 mm / 460 mm |
| Width x height | 600 x 275 mm |
| Weight | 18.8 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) Combine Harvester |
| Availability | In stock, ready to ship |
What this auger does
The feeding auger works under the heaviest mechanical load on the machine, gripping and forcing whole crop through a reducing opening. Its flight edges and the tapered surface take direct contact with stalks, so they wear or bend where a horizontal grain auger would only see loose grain. A deformed cone no longer feeds evenly, producing lumpy, uneven loading into the threshing rotor rather than a steady mat.
The tapered feeding auger against the straight horizontal augers
This is a converging cone that changes the crop width from 485 mm down to 460 mm and feeds under pressure, whereas the 2374 and 2378 augers are straight tubes that move already-threshed grain or chaff sideways at a constant diameter. They are not interchangeable: the feeding auger mounts at the feeder entrance and is more than twice the weight.
Fitting notes
Set the cone on a clean, square seat and verify it runs true before the drive is coupled. The gap around the taper and the adjustable fingers is a manual setting, not a guess: the service manual gives it, because a loose opening lets stalks slip and bunch while an over-tight one invites a jam. A few hand rotations will show any point of contact, after which the mounts can be locked and the bearings greased per the manual.
Before you fit it
Inspect the feeder floor and any retractable fingers alongside the auger, since worn fingers or a scored floor can cause the same feeding fault.
Signs it needs replacing
- Bent or rounded flight edges on the tapered surface, causing uneven feeding
- Crop bunching or surging into the feeder instead of a steady mat
- The cone rubbing its housing from a bent shaft
- Worn end journals or bearings showing as vibration and noise
Compatibility and cross reference
Models covered
Listed for the FM WORLD 4LZ-6.0P Ruilong feeder house; confirm the 485/460 mm tapered diameters before ordering.
Confirming the right part
Match W2.5K-02S-02-02-00B-00 and the tapered 485/460 mm form. This is a feeding cone, not a straight auger.
Reading the old part
A tapered auger: 485 mm at the upper end, 460 mm at the lower, 600 x 275 mm envelope, 18.8 kg. Because the two ends differ, a tapered part fitted the wrong way round still turns and still feeds — badly. Check which end carries the larger diameter before it goes in.
Questions we are asked about this auger
Why does the machine feed in lumps and sometimes jam at the rotor?
A worn or bent tapered feeding auger cannot gather and compress the crop evenly, so material enters the feeder in uneven batches. Check the taper and flight edges, and confirm the clearance is set to the manual.





