12V Horn DL128G/DL129G (118 x 90 x 40 mm) for FM WORLD Combines
The DL128G/DL129G horn is a 12V audible warning unit measuring 118 x 90 x 40 mm and weighing 0.22 kg, used to alert people around the combine during operation.
Horn identification
| Part reference | DL128G/DL129G |
| Component | Electric warning horn |
| Nominal voltage | 12 V |
| Overall dimensions | 118 x 90 x 40 mm |
| Mass | 0.22 kg |
| System | Audible warning |
Producing the warning sound
When the horn circuit is energised, the unit converts electrical power into a loud warning tone. It gives operators a direct way to warn people near the machine before a movement or manoeuvre.
The horn and the reverse horn switch
DL128G/DL129G is the sound-producing unit. JK635A is only the reverse-actuated switch that triggers a warning circuit; replacing the switch cannot repair a failed horn, and replacing the horn cannot correct a switch that never closes.
Installing the 12V horn
Isolate the power, attach the horn to the existing bracket without blocking the sound outlet, and connect the 12V wiring with firm, clean terminals.
Position the outlet so water and crop debris are less likely to collect inside. Reconnect power and operate the control to confirm a clear sound without delay or rattling.
Common causes of a weak or silent horn
- Internal diaphragm or contact wear
- Water and dust entering the sound outlet
- Corroded terminals reducing the electrical supply
- A loose bracket causing vibration and poor sound
- Broken wiring between the switch and horn
- Impact cracks in the horn housing
Ordering checks
Mounting: 12V audible warning circuit on the FM WORLD 4LZ-6.0P combine harvester.
Confirmation: Quote both references, DL128G/DL129G, and confirm the 118 x 90 x 40 mm body and 0.22 kg mass.
Dimensions to match: Check the 12V supply, terminal arrangement, bracket position and 118 x 90 x 40 mm dimensions against the old horn.
Switch, relay and control parts
Horn questions
Is the reverse switch included?
No. This listing is the horn. The JK635A reverse horn switch is a separate control part.
The horn is weak; must it be replaced?
First check the 12V supply, earth connection, terminals and bracket. Replace the horn if those are sound but its tone remains weak.
Identification of DL128G/DL129G before ordering
Order DL128G/DL129G when the warning unit itself is weak or silent; test the supply and switch first, because no voltage at the horn terminals points to another part of the circuit.




