,

Oil Seal (B30X45X10)

Oil Seal (B30X45X10). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Oil Seal B30X45X10 for FM WORLD 6.0P

This oil seal fits a 30 mm shaft on the FM WORLD 4LZ-6.0P, with a 45 mm outer diameter and a 10 mm wide case, at 0.02 kg. It is a standard rotating-shaft seal used where a compact housing retains lubricant behind a small shaft.

Specifications

Part numberB30X45X10
TypeStandard rotating-shaft oil seal
Shaft diameter30 mm
Outer diameter45 mm
Width10 mm
Weight0.02 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

The seal combines an elastomer lip, a garter spring and a pressed case. The spring keeps the lip in even contact with the 30 mm shaft, holding lubricant in the housing, while the case is an interference fit in the 45 mm bore. The lip is intended to run on a thin oil film, not on a dry shaft, which is why it is lightly oiled at assembly. Heat and age harden the rubber over a long service life, and once the lip loses its flex it can no longer follow the shaft and oil begins to pass.

30 mm versus the smaller 25 mm seal

The 25 mm HST seal looks similar in style but is a different part: 25 versus 30 mm on the shaft, 35 versus 45 mm outside and 6 versus 10 mm wide. Because every dimension differs, the two cannot be interchanged, and a seal sized by appearance alone will either not fit the bore or leave a gap at the shaft.

Fitting notes

Drive the seal square into the 45 mm bore with a flat tool on the case, and apply a light film of the housing lubricant to the lip and clean shaft. The spring side faces the oil. Protect the lip as it crosses keyways or splines. Orientation and shaft checks follow the service manual.

Before you fit it

Look closely at the shaft surface where the lip sits. A polished groove or rust spot means the new lip contacts an uneven track and can weep from the start.

Signs this part needs replacing

  • Oil wetting the housing face and catching dust around the shaft
  • A hard or cracked lip that no longer follows the shaft
  • A loose or missing garter spring
  • Leakage around the outside of the case rather than through the lip

Compatibility and cross-reference

Where it fits

Standard rotating-shaft position on the FM WORLD 4LZ-6.0P, in a compact lubricant housing.

Confirming the correct part

Confirm by the 30 mm shaft, 45 mm outer diameter and 10 mm width, part number B30X45X10.

Reading the old part

Measure the shaft and bore. The 30 by 45 by 10 mm dimensions identify the seal even without a readable tag.

Frequently asked questions

How is this different from the 25 mm HST seal?

Every dimension is larger: 30 mm shaft, 45 mm OD and 10 mm width against 25/35/6. They are not interchangeable even though the style is the same.

Where does this seal usually leak first?

Most often through a hardened lip that has lost flex, or around a worn shaft groove. Checking the shaft track before fitting avoids repeating the leak.

Related parts