,

Oil Seal (25*35*6)

Oil Seal (25*35*6). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

HST Oil Seal 25×35×6 for FM WORLD 6.0P

This is a small oil seal for the HST and hydraulic drive on the FM WORLD 4LZ-6.0P, fitting a 25 mm shaft, 35 mm outer diameter and only 6 mm wide, at 0.02 kg. Its thin section seals a compact hydraulic housing where space is tight.

Specifications

Part number25*35*6
TypeCompact HST oil seal
Shaft diameter25 mm
Outer diameter35 mm
Width6 mm
Weight0.02 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

In the HST drive this seal keeps hydraulic oil inside the housing around a small rotating shaft. The elastomer lip is held against the shaft by a garter spring, and the narrow 6 mm case is pressed into the bore. Because HST pumps and motors work to very close internal clearances, oil kept clean and kept inside the housing matters: a slow external leak lowers the oil level over time, and any dust drawn in through a failing seal becomes abrasive in the pump. A thin oil film under the lip is normal and keeps the rubber from running dry.

Small envelope, careful fitting

This is the smallest seal in the set and the easiest to cock in the bore because the case is only 6 mm wide. A wider seal tolerates a slightly uneven press better; here a tilted lip leaks immediately, so a flat driver and square alignment are essential.

Fitting notes

Press it in perfectly square with a driver sized to the small case, and put a light film of clean hydraulic oil on the lip and shaft before fitting. The spring faces the oil being retained. Guide the lip over any keyway with a sleeve so it cannot be nicked. Fluid type and filling follow the service manual.

Before you fit it

Check the small bore and the 25 mm shaft for marks before pressing the new seal in. On a section this narrow, even a small burr can stop the thin case seating.

Signs this part needs replacing

  • A film of hydraulic oil appearing around the shaft and housing joint
  • A tilted or pinched lip from fitting, weeping from the first run
  • Hardened rubber that has lost its flex against the shaft
  • Dropping HST oil level between routine checks

Compatibility and cross-reference

Where it fits

HST and hydraulic drive housing on the FM WORLD 4LZ-6.0P, sealing a 25 mm rotating shaft.

Confirming the correct part

Confirm by the 25 mm shaft, 35 mm outer diameter and the very thin 6 mm case, part number 25*35*6.

Reading the old part

The 6 mm narrow section and 25 mm lip identify this compact HST seal; measure it against the small bore before ordering.

Frequently asked questions

Why does this seal need extra care when fitting?

At only 6 mm wide the case has little room to self-align, so it is easily pressed in crooked. A square driver and even pressure prevent a tilted lip that leaks.

Does a small external HST leak matter?

Yes. It lowers the hydraulic oil level and can let dust enter, and HST components are sensitive to contamination. A weeping seal should be replaced rather than watched.

Related parts