Oil Seal FB55×75×8 for FM WORLD 6.0P
This oil seal fits a 55 mm shaft on the FM WORLD 4LZ-6.0P, with a 75 mm outer diameter and an 8 mm wide case, at 0.02 kg. It pairs a large shaft with a relatively narrow section, used where a rotating shaft exits a lubricated housing.
Specifications
| Part number | FB55×75×8 |
|---|---|
| Type | Rotating-shaft oil seal |
| Shaft diameter | 55 mm |
| Outer diameter | 75 mm |
| Width | 8 mm |
| Weight | 0.02 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
The garter spring loads the elastomer lip against the 55 mm shaft so lubricant stays in the housing, and the case is pressed into the 75 mm bore. At only 8 mm wide, the section is narrow for such a large shaft, so the lip and case rely on correct alignment rather than extra width. As with other rotary seals, a thin oil film under the lip is the designed running state and guards against dry heat. The large shaft also means any wear groove in its surface is proportionally harder for a new lip to follow.
Close to the 52 mm skeleton seal, but not the same
The engine skeleton seal fits a 52 mm shaft in a 72 mm bore and is 12 mm wide; this part is 55, 75 and 8 mm. The numbers are close enough to confuse, but the shaft, bore and width all differ and the construction is not identical, so mixing them produces a poor fit.
Fitting notes
Press square with a driver that bears on the case, and lightly oil the lip and the clean shaft with the housing lubricant. The spring faces the retained oil. Because the section is narrow, take extra care the case does not tilt, and guide the lip over splines using a sleeve. Bore and shaft inspection follow the service manual.
Before you fit it
Examine the large shaft for a worn track before fitting. On a 55 mm shaft a scored or grooved surface is the common reason a new seal still weeps.
Signs this part needs replacing
- Oil streaking out from the shaft and housing joint
- A narrow case pressed in crooked, leaking from one side
- Hardened or torn lip rubber
- A worn groove in the shaft that the new lip cannot seal
Compatibility and cross-reference
Where it fits
Rotating-shaft position on the FM WORLD 4LZ-6.0P, at a large 55 mm shaft leaving a lubricated housing.
Confirming the correct part
Confirm by the 55 mm shaft, 75 mm outer diameter and 8 mm narrow case, part number FB55×75×8.
Reading the old part
The combination of a large 55 mm lip with an 8 mm section distinguishes this seal; measure the shaft and bore to confirm.
Frequently asked questions
Can this replace the 52 mm skeleton seal?
No. The shaft is 55 rather than 52 mm, the bore 75 rather than 72 mm and the width only 8 mm. Close dimensions do not make the parts interchangeable.
Why is the case narrow for such a large shaft?
The design relies on correct alignment and the garter spring rather than extra width. That makes square pressing especially important to avoid a tilted leak.





