,

Inner Skeleton Rotating Shaft Lip Seal Ring (DR52×72×12)

Inner Skeleton Rotating Shaft Lip Seal Ring (DR52×72×12). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Inner Skeleton Rotating Shaft Lip Seal DR52×72×12 for FM WORLD 6.0P

This is a metal-cased skeleton lip seal for a rotating shaft on the FM WORLD 4LZ-6.0P, fitting a 52 mm shaft, 72 mm outer diameter and 12 mm wide, at 0.03 kg. The rigid inner skeleton gives the seal a firm, square press fit in the engine housing bore.

Specifications

Part numberDR52×72×12
TypeInner skeleton rotating shaft lip seal
Shaft diameter52 mm
Outer diameter72 mm
Width12 mm
Weight0.03 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

The skeleton is a stiff metal ring bonded into the seal. It keeps the outer case round and spreads the press fit evenly around the bore, which is why skeleton seals are used where a soft rubber outer ring might shift. The elastomer lip, loaded by a garter spring, contacts the 52 mm shaft and holds engine oil behind it. A thin oil film under the lip is the intended running condition; the seal is built to ride on that film, and a completely dry lip runs hot and hardens early.

Skeleton case against a rubber-coated outer ring

A rubber-coated seal relies on the elastomer outer ring for its bore fit; this skeleton part uses a rigid metal case that locates precisely in the machined bore. Both fit a 52 mm shaft, but the bore design decides which is correct, so they cannot be swapped on shaft size alone.

Fitting notes

Drive the seal in square with a flat tool against the metal case, and coat the lip and the clean shaft track with a light film of the same engine oil before fitting. The lip and spring face the oil being retained. Cover splines and threads with a sleeve while the seal passes them so the lip is not cut. Lead-in and bore checks follow the service manual.

Before you fit it

Inspect the shaft at the exact point the lip contacts it. A polished groove or a rough, scored track means a new seal will weep from the same spot unless the shaft is repaired or replaced.

Signs this part needs replacing

  • Oil seeping past the lip and collecting around the housing face
  • A lip that has turned hard or brittle from heat and age
  • Scoring on the shaft track that no new lip can follow
  • A case that has turned loose in the bore, leaking around the outside

Compatibility and cross-reference

Where it fits

Engine rotating-shaft position on the FM WORLD 4LZ-6.0P, sealing engine oil at a 52 mm shaft in a machined bore.

Confirming the correct part

Confirm by the 52 mm shaft, 72 mm outer diameter, 12 mm width and the rigid metal case, part number DR52×72×12.

Reading the old part

The stiff metal case and the 52 mm lip identify this skeleton seal; measure the bore and shaft rather than relying on a worn tag.

Frequently asked questions

What does the inner skeleton do?

It is a rigid metal ring that keeps the seal round and gives a firm, even press fit in the bore so the case cannot shift in service.

Why is a little oil under the lip acceptable?

The lip is designed to ride on a thin oil film. That film prevents dry friction and heat. A dry lip wears and hardens faster, so the lip is lightly oiled before fitting.

Related parts