Oil Seal Combination W2.5DA-03H-27-06-00B for FM WORLD 6.0P
This is a multi-lip combination oil seal for the FM WORLD 4LZ-6.0P, built around a 29 mm shaft, 78 mm outer diameter and 18 mm wide body, weighing 0.15 kg. The wider 18 mm section carries more than one sealing lip so the unit can hold lubricant in and keep field dust out at the same housing.
Specifications
| Part number | W2.5DA-03H-27-06-00B |
|---|---|
| Type | Multi-lip combination oil seal |
| Shaft diameter | 29 mm |
| Outer diameter | 78 mm |
| Width | 18 mm |
| Weight | 0.15 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
A single-lip seal mainly keeps oil on one side; this combination unit stacks several lips in one rigid body so the inner lip retains lubricant while an outer lip blocks soil and chaff dust. That matters on a chassis position, where the shaft passes from an oil-filled housing out into a dusty field. The lips are elastomer, and a garter spring behind the primary lip keeps even pressure on the shaft as the rubber ages. A narrow oil film under each lip is normal and expected, because the lips ride on that film rather than scrape metal to metal.
Why a combination body is wider
A plain oil seal of a similar shaft size uses one lip and a thin metal case. This part is 18 mm wide and heavier at 0.15 kg because the extra lips and the reinforced case need the room. The two are not interchangeable: fitting a thin single-lip seal here leaves the dust side unprotected.
Fitting notes
Press the seal square into the bore with a driver that contacts the case, not the lips, and put a light film of the housing oil on the lip and the clean shaft before assembly. The spring side faces the lubricant it is meant to retain. Protect the lips as they pass splines or keyways so a sharp edge cannot nick a lip. Shaft preparation and orientation follow the service manual.
Before you fit it
While the housing is open, run a finger around the shaft track and the bore for burrs, grooves or rust. A new multi-lip seal still leaks if the shaft under the lip is already worn into a groove.
Signs this part needs replacing
- An oily or wet streak running down from the housing, with dirt sticking to it
- Hardened or cracked lips that no longer flex against the shaft
- A dislodged spring or a lip folded back during an earlier fitting
- Oil level dropping even though the housing case itself is sound
Compatibility and cross-reference
Where it fits
Chassis and frame sealing position on the FM WORLD 4LZ-6.0P, where a rotating shaft exits an oil-filled housing.
Confirming the correct part
Confirm by the 29 mm shaft, 78 mm outer diameter and the 18 mm wide multi-lip body, together with part number W2.5DA-03H-27-06-00B.
Reading the old part
Count the lips and measure the width. An 18 mm body with more than one lip identifies this combination seal even when the tag is missing.
Frequently asked questions
What makes this a combination seal rather than a normal oil seal?
It carries several lips in one 18 mm wide body so it can retain oil and exclude dust at the same time. A standard seal uses one lip and a thinner case.
Can I substitute a single-lip seal with the same shaft size?
No. The shaft diameter alone does not make them interchangeable. The combination body also seals the dust side, which a single-lip part leaves open.





