,

Tension Shaft (W2.5DA-03B-27-08)

Shaft W2.5DA-03B-27-08. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Tension Shaft for FM WORLD 4LZ-6.0P Chassis

This tension shaft carries the tensioner that holds correct belt or chain tension on the FM WORLD 4LZ-6.0P, 200 mm long with 14 mm end journals and a 30 mm middle section, weighing 0.8 kg. It lets the idler turn while its position is adjusted.

Shaft specification

Part numberW2.5DA-03B-27-08
Part typeTension shaft
Length200 mm
End journals14 mm
Middle section30 mm
Weight0.8 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Keeping the drive tensioned

The idler pulley or wheel turns on the shaft while the mounting position is adjusted to take up slack, so the tension shaft both supports the rotating part and defines the working tension of the belt or chain.

Adjustment against wear

Correct tension is a balance: too slack and the belt or chain slips or slaps, too tight and the shaft and its bearings carry extra load. The adjustment is set to the service manual rather than tightened by feel.

Fitting and setting

Fit the idler on the shaft and confirm it turns freely, then mount the assembly and set the adjustment to the manual before locking it.

After fitting, check the tension and confirm the shaft is not overloaded, then rotate by hand to watch the idler track without wobble.

When the tension shaft is replaced

  • A worn journal that lets the idler wobble
  • Seizure where the idler will not turn
  • Bending from over-tight adjustment
  • Wear at the mounting or adjustment points
  • Noise from a loose or stiff idler
  • A fatigue crack at the section change

Ordering details

Mounting: It is mounted in the chassis housing at the adjustment point, carrying the idler that takes up the slack.

Verify: Verify part number W2.5DA-03B-27-08 and the 200 mm length.

Dimensions to match: Verify the 14 mm journals and 30 mm middle section suit the idler and its mount, and confirm the adjustment range before locking.

Related chassis parts

Common questions

What does a tension shaft do?

It carries the idler that maintains belt or chain tension, and its adjusted position sets the correct working tension.

Why is over-tightening a problem?

It adds load to the shaft and its bearings and can bend the shaft, while slack adjustment causes slip or slap, so the manual value is used.

W2.5DA-03B-27-08 identification before ordering

Look for the adjustment fitting at the mount to tell this 200 mm shaft from the other chassis parts. Quote W2.5DA-03B-27-08, or send a photo of the idler and shaft together with the dimensions if the stamping is gone.

Request a Quote Now