,

Spline Shaft (WD.4M.10-02)

Shaft WD.4M.10-02. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Spline Shaft (18 Splines) for FM WORLD 4LZ-6.0P

This spline shaft carries torque through 18 machined splines on the FM WORLD 4LZ-6.0P, 285 mm long with 20 / 35 / 25 mm sections and weighing 1.6 kg. The splines drive a mating part while allowing it to slide along the shaft.

Spline specification

Part numberWD.4M.10-02
Part typeSpline shaft
Length285 mm
Sections20 / 35 / 25 mm
Splines18
Weight1.6 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Torque with axial movement

The splines are a set of parallel teeth around the shaft that engage a matching hub, spreading the torque over many teeth instead of a single key. The hub can slide axially along the splines while still being driven, which is the purpose of the design.

Spline wear and backlash

Because the load is shared across the splines, wear appears as thinning or rounding of the teeth and increasing backlash rather than a single sheared key. Worn splines let the driven part move and knock under load.

Fitting and lubricating

Slide the mating hub along the full travel to confirm it moves freely without catching, then fit the bearings and check the end float. Confirm every spline engages before securing.

Lubricate the splines as the service manual specifies, since dry sliding surfaces fret and wear quickly, and confirm the shaft is aligned so the hub does not bind.

When a spline shaft is changed

  • Worn or rounded spline teeth
  • Backlash and knocking as the hub takes up load
  • Fretting or scoring along the splines
  • A bent shaft or runout
  • Stiff travel where the hub will not slide
  • Cracking at the change of section

Ordering details

Mounting: It is fitted in the chassis housing where the splined hub slides along it, supported by bearings at the ends.

Verify: Verify part number WD.4M.10-02 and count the 18 splines.

Dimensions to match: Count the 18 splines and confirm the 20 / 35 / 25 mm sections match the hub and bearings, with the full sliding travel free.

Related chassis parts

Common questions

Why use splines instead of a key?

Splines share the torque over many teeth and allow the driven hub to slide axially while still being driven, which a single key cannot do.

How is spline wear recognised?

By thinning or rounding of the teeth and increasing backlash, with knocking as the hub takes up the load.

WD.4M.10-02 identification before ordering

The splines are the identifying feature: count 18 teeth along the 285 mm shaft. Reference WD.4M.10-02 when ordering, or send a photo showing the spline count and the section diameters if the number is worn.

Request a Quote Now