,

Passive Wheel Shaft (W2.5E-01B-02-02-02)

Shaft W2.5E-01B-02-02-02. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Passive Wheel Shaft for FM WORLD 4LZ-6.0P Header

This shaft carries the passive (idler) wheel in the header conveyor of the FM WORLD 4LZ-6.0P, 465 mm long and 28 mm in diameter, weighing 2 kg. It supports the wheel as the conveyor loop turns around it.

Shaft dimensions

Part numberW2.5E-01B-02-02-02
Part typePassive wheel shaft
Length465 mm
Diameter28 mm
Weight2 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Supporting the idler wheel

The passive wheel turns on the shaft at the end of the conveyor loop, guiding and tensioning the chain as it returns. The shaft itself is fixed while the wheel rotates around it, so the bearing surfaces are where wear is concentrated.

Journal wear under the loop

The tension of the loop pulls across the wheel and therefore across the shaft, and any misalignment makes the wheel run to one side and wear the journal unevenly. The wheel and shaft are checked together for play.

Fitting the wheel

Fit the wheel and its bearings on the shaft and confirm it turns freely, then mount the assembly square so the loop tracks the centre of the wheel.

Set the loop tension to the service manual and confirm there is no end play, then rotate by hand to check the wheel runs true without wobble.

Replacement signs

  • A worn or scored journal
  • Play or wobble in the wheel
  • Bending from the tension of the loop
  • Uneven wear from misalignment
  • Seizure where the wheel will not turn
  • Noise and chain slap at the idler

Ordering information

Mounting: It is fixed at the end of the header conveyor, with the passive wheel turning on it as the loop returns.

Verify: Verify part number W2.5E-01B-02-02-02 and the 465 mm length.

Dimensions to match: Confirm the 28 mm diameter and 465 mm length fit the wheel bearings and the mount, and check the loop tracks the centre.

Related conveyor parts

Questions answered

Does the shaft rotate or stay fixed?

It is a fixed shaft while the passive wheel turns on it, so the bearing surfaces and lubrication are the critical points.

What causes uneven wear?

Misalignment that makes the loop run to one side of the wheel, wearing the journal unevenly and shortening the wheel life.

W2.5E-01B-02-02-02 identification before ordering

This is the longest of the header shafts at 465 mm and a single 28 mm diameter, so it is easy to tell apart. Quote W2.5E-01B-02-02-02, or send a photo of the shaft and passive wheel with a measurement if the number cannot be read.

Request a Quote Now