Special Gasket W1.8-33-06-07 for FM WORLD 6.0P
This is the small special gasket part number W1.8-33-06-07 for the FM WORLD 4LZ-6.0P, recorded as 4 × Φ35 and weighing 0.03 kg. It is a purpose-made sealing gasket supplied for a specific joint rather than a general-purpose sheet.
Specifications
| Part number | W1.8-33-06-07 |
|---|---|
| Type | Special sealing gasket |
| Recorded size | 4 × Φ35 |
| Weight | 0.03 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
As a shaped gasket it is made to match one particular sealing face, so its value lies in the exact form rather than in the material alone. Once compressed between the two mating parts it closes the joint and prevents leakage, and it should be treated as a matched part for that location rather than cut or substituted.
Correct gasket against a makeshift washer
A joint that needs a shaped gasket should not be sealed with a generic washer or extra sealant, which rarely follows the face and can fail or squeeze into the mechanism. Fitting the part made for the joint avoids a repeat leak.
Fitting notes
Clean both mating faces fully and fit the gasket in the correct orientation, then tighten the fixings evenly so the pressure is spread across the whole seal. It is single-use and must be replaced whenever the joint is opened.
Before you fit it
Confirm the part against the service drawing before fitting, since a special gasket is identified by its exact form. Keep the joint protected from dirt while it is apart.
Signs this part needs replacing
- A crushed, hardened or torn gasket that no longer seals
- Leakage appearing at the joint after service
- A seal that has taken a set and cannot be reused
- Cracks or splits found when the part is removed
- Uneven compression marks showing a misaligned fit
- Dirt or moisture passing a gasket that has failed
Compatibility and cross-reference
Where it fits
Supplied for the specific joint on the FM WORLD 4LZ-6.0P identified by part number W1.8-33-06-07.
Confirming the correct part
Confirm by part number W1.8-33-06-07 and the recorded 4 × Φ35 form.
Reading the old part
Match the shape and size to the sealing face rather than relying on a generic replacement.
Frequently asked questions
What makes this a ‘special’ gasket?
It is purpose-made to match one specific joint and size, so it is fitted by part number rather than cut from a generic sheet.
Can it be reused after the joint is opened?
No. Like other gaskets it is compressed once and should be replaced with a fresh part whenever the joint is disassembled.




