Intake Pipe Gasket ZN490QA-02005 for FM WORLD 6.0P
This is the intake pipe gasket part number ZN490QA-02005 for the FM WORLD 4LZ-6.0P, a thin 418 × 65 × 1 mm seal weighing 0.02 kg. It sits between the intake pipe and the cylinder head and closes the joint against air leakage.
Specifications
| Part number | ZN490QA-02005 |
|---|---|
| Type | Intake pipe sealing gasket |
| Size | 418 × 65 × 1 mm |
| Weight | 0.02 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
The gasket fills the small gaps in the joint so every breath of air enters the cylinder through the intended path rather than leaking past the flange. On a diesel that relies on a measured air charge, a broken seal lets air slip in unfiltered and unmeasured, upsetting the balance the engine needs to run smoothly. Being only 1 mm thick, it works by being compressed evenly between two flat faces rather than by any force of its own.
Intake leak against a fuel problem
A hissing intake joint and a fuel fault can both produce rough running, so inspect the gasket and flange first while the engine is idling. A confirmed air leak at the pipe is far cheaper to correct than chasing the injection system.
Fitting notes
Lift the pipe, scrape off every trace of the old gasket and fit the new one on clean, flat, dry faces, then tighten the fixings evenly. Gaskets are single-use, so a part that has already been compressed should never be refitted.
Before you fit it
Check the flange itself is not warped or scored, since even a new gasket cannot seal a damaged face. Keep the open intake covered while the pipe is off so no dirt drops into the head.
Signs this part needs replacing
- Hard, brittle or cracked gasket from heat and age
- A blown section that lets air leak at the flange
- Rough idle or uneven running from an air leak
- Hissing at the intake joint when the engine runs
- Dust streaks showing air has bypassed the filter
- A gasket stuck flat and torn when the pipe was removed
Compatibility and cross-reference
Where it fits
Fitted between the intake pipe and cylinder head of the FM WORLD 4LZ-6.0P, compressed by the pipe fixings.
Confirming the correct part
Confirm by part number ZN490QA-02005 and the shape of the flange and bolt holes.
Reading the old part
Match the outline and port cut-outs to the old seal rather than the tag, since the gasket must follow the joint exactly.
Frequently asked questions
Why does an intake air leak matter on a diesel?
The engine expects a controlled air charge, so air entering through a bad seal is unmeasured and unfiltered, causing rough running and letting dust wear the cylinders.
Can the old gasket be reused if it looks intact?
No. Once compressed it has already taken a set and will not seal evenly a second time, so a fresh gasket is required whenever the pipe is removed.





