Connecting Rod Bearing Kit 4G33TC-053000 for FM WORLD 6.0P
This is the connecting rod big-end bearing set for the 4G33TC engine in the FM WORLD 4LZ-6.0P, supplied as a kit of half-shell inserts, package size 65 × 35 × 22 mm, weight 0.07 kg. The thin shells sit between each connecting rod big end and its crankshaft journal.
Specifications
| Part number | 4G33TC-053000 |
|---|---|
| Type | Connecting rod big-end shell bearing set |
| Package size | 65 × 35 × 22 mm |
| Weight | 0.07 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong), 4G33TC engine |
| Availability | in stock, ready to ship |
What this part does
These are plain bearings, not rolling bearings. Each shell is a steel-backed half-liner faced with bearing alloy, and the journal rides on a pressurised wedge of engine oil once the engine runs. That is why the bearings depend on a precise oil clearance and on healthy oil pressure: as the lining wears, the clearance grows and the oil film loses the support it was designed for. The split halves let the bearings be fitted around the journal without removing the crankshaft, and the two shells of a position are matched and must not be swapped between rods.
Why the shells are split halves
A sealed rolling bearing is a complete unit that presses onto a shaft. These inserts are two thin half-shells that clamp inside the rod cap, so they can be renewed in place. They have no moving parts of their own and only work when the journal and oil supply are in good condition.
Fitting notes
Fit the shells into clean, dry seats and make sure the locating tabs engage. Lubricate the bearing surface with clean engine oil before fitting the cap, keep the cap on its matched rod, and tighten to the torque and sequence in the service manual. Never file the caps or add shims to take up clearance.
Before you fit it
Inspect the crankshaft journal for scoring, a polished groove, or taper while the rod is off, and confirm the oil hole is clear. New shells cannot restore oil pressure on a worn or damaged journal.
Signs this part needs replacing
- Low oil pressure warning or gauge reading, as worn shells open the clearance
- A deep knocking from the engine that rises with engine speed
- Fine metal flakes in the oil or filter, showing lining material
- A spun bearing, where the shell turns in the rod and locks the engine
Compatibility and cross-reference
Where it fits
Connecting rod big ends inside the 4G33TC engine of the FM WORLD 4LZ-6.0P, on the crankshaft journals.
Confirming the correct part
Confirm by part number 4G33TC-053000 and by the journal size of the 4G33TC crankshaft before ordering.
Reading the old part
Read the markings on the back of the old shells and measure the journal. The half-shell form and locating tab identify the set without relying on worn packaging.
Frequently asked questions
Do these bearings need grease when fitted?
No. They are engine-oil lubricated plain bearings. Coat them with clean engine oil at assembly; the running oil film does the rest, and grease would not belong in this location.
Can I replace just one rod bearing?
The kit is intended to be fitted as a set so every big end shares the same condition. Replacing a single shell leaves the older worn bearings controlling overall oil pressure and wear.




