Reel Bar Weld II (18 Tines) for FM WORLD 4LZ-6.0P Header
This is the second-position welded reel bar for the FM WORLD 4LZ-6.0P, also 2140 mm long but carrying 18 tines, 8.5 kg. It works alongside the 17-tine bar on the same reel.
Bar measurements
| Part number | W2.0B-01B-01-05Q-15-00 |
| Part type | Welded reel bar (position II) |
| Bar length | 2140 mm |
| Tines | 18 |
| Tooth length | 240 mm |
| Weight | 8.5 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
Role of the second bar
Mounted in the next reel position, this bar follows the first one through the crop and keeps the sweep continuous. The extra tine fills the spacing so the cut material is guided back without gaps.
Telling the two 2140 bars apart
Although it shares the 2140 mm length, the 18-tine count and the -15 part-number ending identify this as the position-II bar. Fitting an 18-tine bar where a 17-tine one belongs changes the tine spacing.
Fitting the position-II bar
Offer the bar to its reel arms and seat the fixings evenly, then check each of the 18 tines is secure. Rotate the reel slowly to confirm the bar clears the knife guard.
Tighten the end fixings in stages so the bar sits square, and re-check after a short run that nothing has worked loose.
Reasons to replace it
- Impact bending that leaves a visible bow
- Weld cracks where the tube meets the end plate
- Tine holes worn oval so tines lean
- Imbalance and shaking at reel speed
- A broken or missing tine mount
- End fixing points that no longer clamp tight
How to order
Mounting: Header reel on FM WORLD 4LZ-6.0P (Ruilong) combine harvesters.
Confirmation: Give the part number and note 18 tines; we cross-check against the reel position before dispatch.
Dimensions to match: Verify the 2140 mm length, 18 tines and the end mounting centres on your removed bar.
Other reel bars and tines
Buyer questions
Can I use the 17-tine bar instead?
No, the position calls for 18 tines; changing the count alters the sweep and the part number is different.
Does the bar include all tines?
It comes as the welded bar with its row of 18 tines; count them on delivery against the part number.
Identification of W2.0B-01B-01-05Q-15-00 before ordering
Replace the position-II bar when it is bent or its welds and tine holes are worn; do not swap it for the 17-tine bar even though both are 2140 mm.





