Relief Valve Assembly (2 Pieces) for the FM WORLD 4LZ-6.0P HST Circuit
This compact relief valve assembly, 65 mm long with an 18 mm diameter and supplied as two pieces, protects the HST hydraulic circuit by limiting its pressure.
Relief valve specifications
| Drawing number | WHST40-02-9 |
| Component | Relief valve assembly |
| Length x diameter | 65 x Phi18 mm |
| Set contents | 2 pieces |
| Mass | 0.05 kg |
| Machine | FM WORLD 4LZ-6.0P (Ruilong) |
Protecting the HST from overpressure
When the circuit reaches its opening point, the valve lifts and returns oil to the low-pressure side, keeping the HST below a damaging pressure.
Pressure relief versus directional valves
The other three valves direct where oil goes, while this one guards pressure, so it is a small spring-loaded assembly rather than a spool body.
Fitting the relief valve
Screw the valve into its bore with clean threads, fit the supplied pieces in the correct order, and torque it to the service manual value.
Run the HST through its range and confirm the machine responds normally without the relief opening during ordinary work.
Conditions that condemn the assembly
- Weakened spring opening too early
- Dirt held on the seating face
- Valve sticking closed
- Leakage around the threads
- Loss of force from early opening
- Worn seat from contaminated oil
Checks before ordering
Mounting: HST relief valve assembly of FM WORLD 4LZ-6.0P (Ruilong) harvesters.
Confirmation: Quote the drawing number and note the two-piece set and the 65 x Phi18 mm size.
Dimensions to match: Match the thread and bore to the housing before installing.
The directional and solenoid valves
Buyer questions answered
Why might the HST feel weak?
A tired spring or dirty seat can let the relief open before the working pressure is reached.
Should the setting be adjusted?
Only follow the service manual; blind adjustment can either weaken drive or risk overpressure.
Identification of WHST40-02-9 before ordering
Replace this assembly when the HST feels weak, the relief opens early or the seat is contaminated; do not alter the setting beyond the service manual.





