,

Sensor, Rotating Speed (W2.0-06-01-16-00)

Replacement part for FM WORLD 4LZ-6.0P. Verify fitment by part number W2.0-06-01-16-00 and contact us for ordering support.

Rotating Speed Sensor W2.0-06-01-16-00 (155 mm, 25 mm Body) for FM WORLD

The W2.0-06-01-16-00 rotating speed sensor, 155 mm long with a 25 mm body diameter and 0.1 kg mass, provides the electrical speed signal used by the harvester control and display system.

Speed sensor data

Part numberW2.0-06-01-16-00
ComponentRotating speed sensor
Length155 mm
Body diameter25 mm
Mass0.1 kg
Measured valueRotational speed

Reading shaft rotation

As the monitored shaft turns, the sensor changes that rotation into an electrical signal. The machine’s control or display circuit uses the signal to report speed and to support the related operating function.

Speed sensing versus oil pressure sensing

This part measures rotation, whereas W2.0-06-01-18-00 responds to engine oil pressure. Their readings serve different circuits, so a similar cylindrical body does not make the two sensors interchangeable.

Fitting the speed sensor

Disconnect the machine power, remove the old sensor without pulling on its cable, and position the replacement in the original mounting location with the connector seated fully.

Keep the original cable route and mounting arrangement. After fitting, start the machine and check that the speed reading responds smoothly through low and higher shaft speeds.

Why the speed signal becomes unstable

  • Sensing element degradation after long service
  • Oil or crop contamination on the sensing end
  • A loose plug causing an intermittent reading
  • Cable insulation rubbed through by vibration
  • Corrosion at the electrical contacts
  • A changed mounting position producing an unreliable signal

Checks before ordering

Mounting: Rotating speed sensing on the FM WORLD 4LZ-6.0P electrical system.

Confirmation: Quote W2.0-06-01-16-00 and check the 155 mm length, 25 mm body and 0.1 kg mass.

Dimensions to match: Compare the connector, mounting arrangement, 155 mm overall length and 25 mm body with the removed sensor.

Related sensors and instruments

Speed sensor questions

Can this replace the oil pressure sensor?

No. This sensor reads rotation, while W2.0-06-01-18-00 reads oil pressure; their circuits and signals are different.

Why does the displayed speed jump up and down?

A loose connector, damaged cable, contamination or an incorrect mounting position can interrupt the signal before the sensor itself fails.

Identification of W2.0-06-01-16-00 before ordering

Use the exact W2.0-06-01-16-00 number when speed is missing or erratic; inspect the plug and cable first so a wiring fault is not mistaken for a failed sensor.

Request a Quote Now