Flameout Wire W2.0-07-02-08-00 (1350 mm, 6 mm Diameter) for FM WORLD
The W2.0-07-02-08-00 flameout wire is a 1350 mm shutdown cable with a 6 mm diameter and 0.2 kg mass, used to transmit the stop control movement.
Flameout wire data
| Part number | W2.0-07-02-08-00 |
| Component | Flameout wire |
| Length | 1350 mm |
| Cable diameter | 6 mm |
| Mass | 0.2 kg |
| Control action | Engine shutdown |
Transmitting the shutdown command
When the stop control is operated, the inner wire moves the connected shutdown lever. A reliable cable route is important because partial travel can leave the stop action incomplete.
Flameout wire and throttle wire
The throttle wire commands engine speed, while the flameout wire is dedicated to the stop function. Their similar construction does not mean their adjusted lengths or fittings are interchangeable.
Fitting the shutdown cable
Let the machine cool before working near engine components. Fit the new cable with the original clips and confirm the stop lever reaches its full position.
Do not over-tighten the adjustment. After fitting, release and reset the control, then verify the shutdown lever returns to its normal running position.
Why shutdown movement becomes unreliable
- Lost motion from a stretched inner wire
- Boot damage allowing dirt into the sleeve
- Rubbing against a hot engine component
- Corrosion at the control end
- A kinked outer housing limiting travel
- Clip failure causing the cable to move during operation
Checks before ordering
Mounting: Engine shutdown circuit on FM WORLD 4LZ-6.0P combines.
Confirmation: Before ordering, reference W2.0-07-02-08-00 and check the 1350 mm length, 6 mm diameter and 0.2 kg mass.
Dimensions to match: Compare the stop-end fitting, control-end fitting, route and length with the old flameout wire.
Engine stop and start cables
Flameout wire questions
Can a throttle wire be used as a flameout wire?
No. The function, adjustment and end fittings must match the specific shutdown application.
What is the main risk of a worn flameout cable?
It may deliver only partial travel, preventing a reliable shutdown command.
Identification of W2.0-07-02-08-00 before ordering
Use this part when the stop control does not transfer full movement; inspect the engine shutdown lever and cable adjustment before replacement.




