,

Reverse Wire (W2.5-07-05-04-00)

Replacement part for FM WORLD 4LZ-6.0P. Verify fitment by part number W2.5-07-05-04-00 and contact us for ordering support.

Reverse Wire W2.5-07-05-04-00 (2500 mm, 8 mm Diameter) for FM WORLD

The W2.5-07-05-04-00 reverse wire is a 2500 mm, 8 mm control cable weighing 0.65 kg, providing the mechanical pull needed for the reverse control circuit.

Reverse wire data

Part numberW2.5-07-05-04-00
ComponentReverse wire
Length2500 mm
Cable diameter8 mm
Mass0.65 kg
Control actionReverse selection

Transferring reverse selection

The fixed outer housing gives the inner wire a stable path over the long route. Operator movement at one end is transferred to the reverse control at the other end.

The reverse wire and the warning horn circuit

This wire selects the mechanical control position. The horn and its reverse switch are separate warning components, and neither replaces the control cable.

Routing the reverse wire

Use the original clips and avoid tight bends during installation. Secure both end fittings before adjusting the cable so the measured travel matches the old unit.

Test selection with the machine power isolated where possible. The control should move fully, hold position and release without the cable rubbing nearby panels.

Why a long reverse cable binds

  • Internal friction after long service
  • A sharp bend pulling the inner wire under load
  • Missing clips allowing the cable to sag
  • Water trapped in a low point of the route
  • Worn end fitting creating lost motion
  • Dirt entry where the protective boot is damaged

Ordering checks

Mounting: Reverse selection circuit for the FM WORLD 4LZ-6.0P.

Confirmation: Match W2.5-07-05-04-00 before purchase, including the 2500 mm length, 8 mm diameter and 0.65 kg mass.

Dimensions to match: Check the full route, end fittings, cable diameter and length against the removed wire.

Long cables and operator controls

Reverse wire questions

Does this include the reverse warning switch?

No. The switch and horn are separate parts; this listing is the mechanical reverse wire.

Why is the long cable difficult to operate?

Tight bends, dirt, corrosion, missing supports or a damaged inner wire can create binding.

Identification of W2.5-07-05-04-00 before ordering

Replace this long reverse wire when selection is incomplete or binding; confirm the target lever and cable clips are serviceable before fitting.

Request a Quote Now