,

Throttle Wire (W2.5-07-08-05-00)

Replacement part for FM WORLD 4LZ-6.0P. Verify fitment by part number W2.5-07-08-05-00 and contact us for ordering support.

Throttle Wire W2.5-07-08-05-00 (1300 mm, 5 mm Diameter) for FM WORLD

The W2.5-07-08-05-00 throttle wire is a 1300 mm control cable with a 5 mm diameter and 0.18 kg mass, used to translate throttle-lever movement into an engine speed command.

Throttle wire data

Part numberW2.5-07-08-05-00
ComponentThrottle wire
Length1300 mm
Cable diameter5 mm
Mass0.18 kg
Control actionEngine speed

Carrying the throttle command

Moving the throttle lever pulls the inner wire through the fixed housing. The connected engine control changes position, giving the operator direct command over engine speed.

A mechanical throttle wire versus an electronic hand throttle

This wire works by mechanical pull. An electronic hand throttle uses an electrical signal, so equal lever movement does not make the two parts interchangeable.

Installing the throttle wire

Remove the old fittings carefully and route the replacement along the same clips. Connect both ends before adjustment so the housing is not placed under tension.

After adjustment, move the lever from idle to full position and release it. The engine control should follow smoothly and return without hanging.

Signs of throttle-cable wear

  • Inner wire stretch after repeated use
  • Dry or contaminated sleeve causing high lever effort
  • Kinked housing preventing full travel
  • Loose cable clips allowing vibration rub
  • Worn end eye or connector
  • Incorrect adjustment producing a high or low idle position

What to verify before ordering

Mounting: Mechanical engine-speed circuit for FM WORLD 4LZ-6.0P equipment.

Confirmation: Use W2.5-07-08-05-00 as the order reference and confirm the 1300 mm length, 5 mm diameter and 0.18 kg mass.

Dimensions to match: Match the end fittings, lever travel, cable length and original routing before installation.

Throttle and handle controls

Throttle wire questions

Why does the engine not reach full speed?

A kinked cable, worn end fitting, incorrect adjustment or restricted engine-side lever can limit travel.

Is this the same as an electronic throttle?

No. This is a mechanical pull cable, not an electronic signal control.

Identification of W2.5-07-08-05-00 before ordering

Select this throttle wire when lever movement is no longer transferred accurately; check the engine-side lever and adjustment first so an external fault is not mistaken for cable failure.

Request a Quote Now