,

Starting Cable Assy (JK430)

Replacement part for FM WORLD 4LZ-6.0P. Verify fitment by part number JK430 and contact us for ordering support.

Starting Cable Assembly JK430 (480 x 40 x 40 mm, 0.35 kg) for FM WORLD

The JK430 starting cable assembly is a mechanical control cable with overall dimensions of 480 x 40 x 40 mm and a mass of 0.35 kg, built to transfer the operator’s starting control movement through the cable run.

Starting cable data

Part numberJK430
ComponentStarting cable assembly
Overall dimensions480 x 40 x 40 mm
Mass0.35 kg
Control actionStarting pull
SystemMechanical control

Transmitting the start control movement

When the operator moves the control, the inner cable carries the pull while the outer housing keeps the route stable. That controlled movement is transferred to the connected starting mechanism.

Mechanical cable versus an electrical start relay

A cable transmits mechanical movement. An electrical relay carries a switched circuit, so a poor mechanical pull cannot be diagnosed in the same way as a missing voltage signal.

Fitting the starting cable

Switch off the power before removal. Release the end fittings without bending the cable sharply, then connect the replacement using the original brackets and adjust the free movement to the maker’s position.

Keep the cable away from hot surfaces and moving parts. After fitting, operate the control several times and confirm that the cable returns fully without binding.

Why a starting cable becomes stiff or slack

  • Fraying of the inner cable
  • Dust and old lubricant making the sleeve stiff
  • A bent end fitting causing partial movement
  • Worn brackets allowing the housing to move
  • Corrosion where moisture enters the cable
  • Over-adjustment leaving the control with no free travel

Checks before ordering

Mounting: Mechanical starting circuit used with FM WORLD 4LZ-6.0P combines.

Confirmation: When ordering, identify JK430 and cross-check the 480 x 40 x 40 mm dimensions and 0.35 kg mass.

Dimensions to match: Compare both end fittings, cable route, overall length and bracket positions with the removed assembly.

Related control cables and handles

Starting cable questions

Can this cable replace an electrical starting relay?

No. This part transfers mechanical movement, while a relay belongs to an electrical switching circuit.

What causes a starting cable to feel stiff?

Dirt, corrosion, a bent route, worn brackets or fraying inside the sleeve can increase operating effort.

Identification of JK430 before ordering

Use JK430 when the mechanical starting control is stiff, slack or unreliable; inspect adjustment and end fittings before replacing the complete cable.

Request a Quote Now