,

Electronic Hand Throttle (W3.5-09A-01YC-03)

Replacement part for FM WORLD 4LZ-6.0P. Verify fitment by part number W3.5-09A-01YC-03 and contact us for ordering support.

Electronic Hand Throttle W3.5-09A-01YC-03 (545 x 70 x 60 mm) for FM WORLD

The W3.5-09A-01YC-03 electronic hand throttle measures 545 x 70 x 60 mm and weighs 0.12 kg. It provides an electrical throttle command from the operator station.

Electronic throttle data

Part numberW3.5-09A-01YC-03
ComponentElectronic hand throttle
Overall dimensions545 x 70 x 60 mm
Mass0.12 kg
Control actionElectronic throttle signal
LocationOperator station

Sending the throttle signal

As the operator moves the handle, the internal control changes the electrical output. The machine control circuit uses that signal to command the throttle position.

Electronic throttle and a mechanical pull wire

A mechanical wire directly pulls a lever. This unit sends an electrical signal and requires the correct connector, mounting position and output circuit rather than a simple cable adjustment.

Installing the hand throttle

Disconnect the power and plug before removal. Mount the replacement on the original bracket, connect the latch fully and check that the handle moves through its full mechanical range.

Avoid stress on the connector during installation. After power is restored, observe smooth response at low, mid and high command positions.

Why an electronic throttle can fail

  • Worn internal position-sensing element
  • Connector corrosion causing an intermittent signal
  • Loose mounting changing the handle position
  • Water entry through a damaged boot
  • Worn return detent
  • Harness fault outside the throttle unit

What to confirm before ordering

Mounting: Electronic throttle command at the FM WORLD 4LZ-6.0P operator station.

Confirmation: Quote W3.5-09A-01YC-03 and confirm the 545 x 70 x 60 mm dimensions and 0.12 kg mass.

Dimensions to match: Match the connector pin arrangement, mounting points, handle travel and part number before fitting.

Electrical and cable controls

Electronic throttle questions

Can this replace a mechanical throttle wire?

No. It outputs an electrical signal and must match the machine’s control circuit.

Why is the throttle response intermittent?

A loose connector, corroded pins, weak mounting or internal sensing wear can interrupt the signal.

Identification of W3.5-09A-01YC-03 before ordering

Choose this electronic hand throttle after the harness and connector have been checked; a wiring fault will not be corrected by replacing the control unit.

Request a Quote Now