,

Unloading Cable Combination (W2.5E-07-05A-08-00)

Replacement part for FM WORLD 4LZ-6.0P. Verify fitment by part number W2.5E-07-05A-08-00 and contact us for ordering support.

Unloading Cable Combination W2.5E-07-05A-08-00 (142 mm, 10 mm Diameter)

The W2.5E-07-05A-08-00 unloading cable combination is a short 142 mm, 10 mm control assembly weighing 0.2 kg, used for the unloading control movement.

Unloading cable data

Part numberW2.5E-07-05A-08-00
ComponentUnloading cable combination
Length142 mm
Cable diameter10 mm
Mass0.2 kg
Control actionUnloading

Transferring the unloading control movement

The compact cable assembly transfers movement from the operator control to the unloading mechanism. Its short route makes correct end fitting alignment especially important.

Short unloading cable and long control wires

Long cables rely on supported routing across the machine, while this short combination is mainly controlled by end fitting fit and local adjustment.

Fitting the unloading cable

Clean the mounting area and inspect both fittings before installation. Secure the assembly without side loading, then check the full unloading control travel.

Make sure the cable does not pinch when the control moves. After adjustment, cycle the control and confirm it returns to the resting position.

Why a short control cable fails

  • Worn end fitting creating slack
  • Dirt in the short sleeve
  • Corrosion at the pivot
  • Misaligned bracket causing side load
  • Inner cable wear after repeated cycles
  • Damaged boot exposing the moving part

What to verify

Mounting: Unloading control fitted to FM WORLD 4LZ-6.0P machines.

Confirmation: Use W2.5E-07-05A-08-00 as the matching reference and check the 142 mm length, 10 mm diameter and 0.2 kg mass.

Dimensions to match: Match the end fittings, bracket position, short length and control travel with the old assembly.

Unloading and operator controls

Unloading cable questions

Why does the unloading control have lost motion?

A worn end fitting, loose bracket or stretched inner cable can reduce transferred movement.

Can a longer control cable be cut to fit?

No. The exact assembly and fittings are required for safe and correct operation.

Identification of W2.5E-07-05A-08-00 before ordering

Use this unloading cable when the short control movement is slack or binding; inspect the connected unloading lever and bracket before replacing the cable.

Request a Quote Now