,

Bearing 6308-2RS

6308-2RS single-row deep groove ball bearing, rubber sealed on both sides. 40 mm bore, 90 mm outside diameter, 23 mm width, 0.64 kg. Replacement for the FM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong) combine harvester. In stock, ready to ship.

Bearing 6308-2RS — 40 x 90 x 23 mm for FM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong)

The 6308-2RS is a heavy-section bearing in a 40 x 90 x 23 mm envelope, sealed on both sides. It is one of the larger sealed bearings on the FM WORLD 4LZ-4.0E and 4LZ-6.0P and is used where a 40 mm shaft has to take load without a lubrication point.

Specifications

Part number6308-2RS
Typesingle-row deep groove ball bearing, rubber sealed on both sides
Bore diameter40 mm
Outside diameter90 mm
Width23 mm
Weight0.64 kg
FitsFM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

Bearing type and load capacity

The 63 series carries the highest load of the three common deep groove families for a given bore. At 0.64 kg this is a substantial part, and its mass and ring thickness are what give it impact resistance where a light bearing would bruise.

One 40 mm bore, three load classes: 6008, 6208 and 6308

The 6008 is 40 x 68 x 15 mm, the 6208 is 40 x 80 x 18 mm and the 6308 is 40 x 90 x 23 mm. Same shaft, three different housing bores and three different capacities. Measure the housing bore first: it decides which of the three you can use, and only then compare ratings.

Fitting notes

With 23 mm of width there is real ring mass to damage. Heat the bearing and check that the housing bore is round and clean before fitting, or the seal will be unevenly loaded.

Before you fit it

Shaft and housing

The 23 mm width leaves little room to lever the ring square, so check the 90 mm bore for taper and the 40 mm journal for a step before starting.

Signs it needs replacing

  • Deep thumping under load, changing with cutterbar engagement
  • Outer ring loose enough to turn slowly in the housing
  • Seal face grooved by abrasive dust
  • A strong heat signature after a few minutes of running

Compatibility and cross reference

Models covered

This number covers the 4LZ-4.0E and the 4LZ-6.0P and is the heaviest sealed bearing of the three 40 mm-bore options.

Confirming the right part

A 40 mm shaft can carry a 6008, a 6208 or this 6308. The bore measurement, 68, 80 or 90 mm, settles which one you have.

Questions we are asked about this bearing

Can the 6308-2RS replace a 6208?

Only if the housing bore is 90 mm rather than 80 mm. They share the 40 mm bore but nothing else in the mounting dimensions.

Related parts