Eccentric Adjusting Shaft W3.5D-01-01-02-13 (925 mm, 25 mm Diameter)
The W3.5D-01-01-02-13 eccentric adjusting shaft is 925 mm long, 25 mm in diameter and 3.5 kg, used in the W3.5D adjustment linkage.
W3.5D eccentric adjustment data
| Part number | W3.5D-01-01-02-13 |
| Component | Eccentric adjusting shaft |
| Length | 925 mm |
| Diameter | 25 mm |
| Mass | 3.5 kg |
| Function | Eccentric adjustment |
Eccentric adjusting shaft role
The offset section moves the linked adjustment point, allowing the header part to be set through the eccentric action.
Eccentric adjusting shaft differences
The W3.5D swing rod shaft supports oscillation, while this shaft specifically establishes the eccentric adjustment.
Eccentric adjusting shaft installation
Record the starting setup before removal and lubricate only the specified service points. Align the eccentric section with the linkage before tightening.
Run the adjustment through its complete range and confirm the linkage returns smoothly without hard contact.
Eccentric adjusting shaft wear checks
- Worn eccentric profile
- Scored 25 mm journal
- Bent 925 mm body
- Damaged linkage face
- Retainer wear
- Adjustment drift
Eccentric adjusting shaft ordering checks
W3.5D eccentric adjustment linkage.
Use W3.5D-01-01-02-13 as the reference, then confirm the 925 mm length, 25 mm diameter and 3.5 kg mass.
Match the offset profile, linkage points, journals and length with the old shaft.
Eccentric adjusting shaft related parts
Eccentric adjusting shaft questions
Does it interchange with the 850 mm eccentric shaft?
No, the length and application differ.
Why record the setup before removal?
It helps restore the header to the same operating position.
Identification of W3.5D-01-01-02-13 before ordering
Select this shaft when the W3.5D adjustment is inaccurate, stiff or affected by wear on the eccentric surface.





