,

Grain Lifting Chain W2.5K-02PB-10A-15

Grain lifting chain for the vertical elevator. Part W2.5K-02PB-10A-15. In-stock replacement for the FM WORLD 4LZ-6.0P header and threshing system.

Grain Lifting Chain (W2.5K-02PB-10A-15) for the FM WORLD 6.0P

This is the grain lifting chain inside the vertical elevator, with 42 joints and a weight of 0.4 kg. It carries the elevator paddles upward, so it works in a vertical run rather than a horizontal one, which changes how its faults appear.

Specifications

Part NumberW2.5K-02PB-10A-15
Part TypeGrain lifting chain, vertical elevator
Joints42
Weight0.4 kg
RunVertical
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

On a vertical run the loaded side always carries weight in one direction, and a chain that has elongated does not ride off sideways; it sags against the return side and the elevator starts to carry grain unevenly. Stiff links are the more dangerous fault here. A stiff link passing over the top sprocket on a vertical run makes a knock that travels down the whole elevator, and grain begins to spill back rather than being lifted. Because the chain is enclosed, these faults are usually heard before they are seen.

Vertical lifting versus the horizontal conveyor chains

The horizontal 08B chains show elongation as jumping on the sprocket; this chain shows it as uneven lifting and spill-back, and its 42 joints are fewer than the conveyor lengths. The joint count and the part number separate it from the other chains, and it should not be replaced with a cut-down length, because the elevator paddles are spaced to the factory chain.

Fitting notes

Work the chain by hand to find stiff links and check the top and bottom sprockets before fitting, since the enclosed elevator makes a second strip-down expensive. Confirm the paddle spacing matches the old chain and that the chain runs clear of the casing. Tension follows the service manual, and the connecting link is fitted with the same orientation rule as the other chains.

Before you fit it

Because this chain is enclosed and vertical, inspect the casing and the sprockets while the elevator is open. A worn bottom sprocket in a dirty elevator will shorten the life of a new chain quickly.

Signs it needs replacing

  • Spill-back or uneven grain delivery at the top
  • Knocking from a stiff link passing over the top sprocket
  • Sag against the return side that adjustment cannot remove
  • Elevator paddles no longer spaced evenly

Compatibility and cross reference

Models covered

The lifting chain of the vertical grain elevator on the FM WORLD 4LZ-6.0P. It is a 42-joint chain with paddle spacing built in, so it is ordered by its part number.

Confirming the right part

Confirm W2.5K-02PB-10A-15 on 42 joints and 0.4 kg. The conveyor chains are longer and carry no paddles.

Reading the old part

Count the joints and check the paddle mounting points. The paddles and their spacing identify this chain even when the number is worn off.

Questions we are asked about this part

Can I replace this chain with a length cut from a standard chain?

Not safely. The elevator paddles mount at fixed spacing on the factory chain, and a cut length rarely matches that spacing, so the elevator carries unevenly.

What is the first sign inside the elevator?

Usually a knock as a stiff link goes over the top sprocket, followed by grain spilling back. Both are reasons to open the elevator rather than waiting for the chain to jump.

Related parts