Threshing Cage Frame (2310 x 1150 x 1300 mm) for FM WORLD 4LZ-6.0P
This welded threshing cage frame, 2310 x 1150 x 1300 mm, supports the cylinder and concave assembly and keeps them in alignment during separation.
Cage frame data
| Drawing number | W3.5H-02HA-01A-00 |
| Component | Welded threshing cage frame |
| Overall dimensions | 2310 x 1150 x 1300 mm |
| Machine | FM WORLD 4LZ-6.0P (Ruilong) |
Housing the cylinder and concave
The cage surrounds the cylinder and concave, holding the separation parts in the correct position while resisting the shaking loads generated during threshing.
Cage frame against the main frame
This cage is a dedicated section frame for the cylinder, while the main chassis frame is the full-length backbone that supports the whole combine.
Mounting the cage frame
Set the cage on its support rails, align the cylinder and concave locations, and secure the fixings per the service manual.
After assembly, confirm the cylinder and concave stay aligned and the cage does not flex against the rotor.
Reasons the cage fails
- Weld fatigue around the cylinder supports
- Cage members bent by impact or overload
- Bolt holes elongated by vibration
- Corrosion across the frame
- Support lugs cracking or tearing
- Misalignment that lets the cylinder rub
What to verify
Mounting: Welded threshing cage of FM WORLD 4LZ-6.0P (Ruilong) harvesters.
Confirmation: Quote the drawing number and confirm the 2310 x 1150 x 1300 mm cage frame.
Dimensions to match: Match the cage dimensions and the cylinder and concave locations to the old part.
Main and rear frames
Common questions
Is the cylinder supplied with this frame?
No, the cage is the welded support; the cylinder and concave are separate parts.
What causes the cage to misalign?
Bent members, elongated holes or cracked support lugs allow the cylinder to move off position.
Identification of W3.5H-02HA-01A-00 before ordering
Select this cage frame when the supports fatigue or the cylinder loses alignment; inspect the cylinder and concave before ordering.





