,

Rear Support Frame (W2.5-04G-05YD-00)

Part W2.5-04G-05YD-00. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Rear Mounting Frame (1020 x 510 x 1135 mm) for FM WORLD 4LZ-6.0P

This welded rear mounting frame, 1020 x 510 x 1135 mm, anchors the tail-end assemblies and keeps the rear structure square under load.

Mounting frame data

Drawing numberW2.5-04G-05YD-00
ComponentWelded rear mounting frame
Overall dimensions1020 x 510 x 1135 mm
MachineFM WORLD 4LZ-6.0P (Ruilong)

Anchoring the tail assemblies

The tail-end components anchor onto this frame, which holds them square and transfers their loads back into the main chassis during filling and unloading.

Mounting frame against the backbone

This frame anchors the tail section only, whereas the backbone runs the full length and the cage supports the threshing cylinder.

Mounting the tail frame

Place the frame at the rear mounting points, align the anchor faces, and secure fasteners per the service manual.

After fitting, confirm the tail assemblies remain square and the frame does not twist under load.

Reasons the anchor fails

  • Anchor welds cracking under repeated rear loads
  • Mounting faces worn or elongated
  • Members bent or pushed out of square
  • Corrosion weakening the rear structure
  • Lugs tearing from the frame
  • Fatigue cracks spreading from the mounts

What to verify

Mounting: Welded rear mounting frame of FM WORLD 4LZ-6.0P (Ruilong) harvesters.

Confirmation: Quote the drawing number and confirm the 1020 x 510 x 1135 mm rear frame.

Dimensions to match: Match the mounting dimensions and the anchor faces to the old frame.

Backbone and cage frames

Common questions

What anchors onto this frame?

The tail-end assemblies, held square and tied back into the main chassis.

How does the rear lose squareness?

Bent members or cracked anchor welds allow the tail components to move out of alignment.

Identification of W2.5-04G-05YD-00 before ordering

Select this rear mounting frame when the anchor welds fail or the tail assemblies lose squareness; inspect the unloading structure before ordering.

Request a Quote Now