,

Connecting Rod Parts (4G33TC-052001B)

Connecting Rod Parts (4G33TC-052001B). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Connecting Rod 4G33TC-052001B for FM WORLD 6.0P

This is a connecting rod for the 4G33TC engine in the FM WORLD 4LZ-6.0P, overall size 245 × 95 × 35 mm, with a 62 mm big end and a 32 mm small end, weight 1.23 kg. It links the piston pin to the crankshaft.

Specifications

Part number4G33TC-052001B
TypeEngine connecting rod
Overall size245 × 95 × 35 mm
Big end62 mm
Small end32 mm
Weight1.23 kg
FitsFM WORLD 4LZ-6.0P (Ruilong), 4G33TC engine
Availabilityin stock, ready to ship

What this part does

The rod converts the piston’s up-and-down force into crankshaft rotation. The small end holds the piston pin, usually through a replaceable bushing, and the split big end clamps around the crankshaft bearing shells. The big-end cap is machined as a matched pair with the rod and is marked for position, so it must never be swapped with another rod. An oil passage carries lubrication between the two ends.

The rod against the bearing kit

The connecting rod is the forged load-bearing body; the bearing shells are separate inserts that sit in the big end. Renewing the bearings does not straighten or repair a bent or damaged rod.

Fitting notes

Keep the cap on its matched rod and observe the orientation marks, fit the bearing shells and small-end bushing correctly, and align the oil hole. Tighten the big-end bolts to the torque and method given in the service manual.

Before you fit it

Check the rod for straightness and the big end and small-end bushing for wear before reassembly. A bent rod, often from a hydraulic lock or valve contact, causes uneven wear and noise even with new bearings.

Signs this part needs replacing

  • Bent or twisted rod after a hydraulic lock or valve-to-piston contact
  • Knocking from a failed big-end bearing or loose cap
  • Worn small-end bushing causing pin noise
  • Bolt or big-end damage that makes the rod unsafe to reuse

Compatibility and cross-reference

Where it fits

Between the piston pin and the crankshaft in the 4G33TC engine of the FM WORLD 4LZ-6.0P.

Confirming the correct part

Confirm by part number 4G33TC-052001B, the 32 mm small end for the piston pin, and the 62 mm big end for the crankshaft.

Reading the old part

Identify the rod by its length and the 62 and 32 mm end sizes, and check the matched cap markings. The orientation and oil passage confirm the correct fitting.

Frequently asked questions

Can the big-end caps be swapped between rods?

No. Each cap is machined as a matched pair with its own rod and marked for position. Swapping caps destroys the bearing fit and can cause a major failure.

How does a connecting rod bend?

Most often from liquid entering a cylinder, such as a hydraulic lock from coolant or fuel, or from valve contact. The rod should be checked for straightness before it is reused.

Related parts