Crankshaft 4G33TC-060004AZZ for FM WORLD 6.0P
This is the crankshaft part number 4G33TC-060004AZZ for the FM WORLD 4LZ-6.0P, a 600 × 185 × 130 mm shaft weighing 24 kg. It is the engine’s main rotating component and turns the up-and-down motion of the pistons into rotation.
Specifications
| Part number | 4G33TC-060004AZZ |
|---|---|
| Type | Engine crankshaft |
| Size | 600 × 185 × 130 mm |
| Weight | 24 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
The main journals spin in the main bearings in the block while the rod journals drive the connecting rods, and the counterweights balance the forces of the pistons. Oil reaches every bearing through drilled passages, the rear flange carries the flywheel and the front snout takes the timing gear and pulley. As each piston fires, the crankshaft collects those pulses and delivers one smooth rotation to the transmission.
Crankshaft fault against a bearing fault
Knocking and low oil pressure often begin with a failed bearing that then scores the journal, so the shaft should be measured rather than assumed bad. A crankshaft with good journals can be reused with new bearings, while a scored or cracked one cannot.
Fitting notes
Assembly belongs in a measured rebuild: the main and rod bearings are selected for the clearances in the service manual and the caps are torqued in sequence, with the rear oil seal and thrust bearings set correctly. Never file or shim the caps to take up wear.
Before you fit it
Before fitting, inspect every journal for scoring and cracks and check they are within grind tolerance, then confirm the oil passages are clear. A shaft removed after a bearing failure must be checked thoroughly, since debris and a damaged journal travel together.
Signs this part needs replacing
- Scored or worn journals that lose oil pressure
- Knocking from the main or rod bearings
- Cracks found at the journals or the flange
- Excessive vibration from a bent or damaged shaft
- A worn thrust surface that allows end float
- Damage following a spun bearing or oil starvation
Compatibility and cross-reference
Where it fits
The central rotating shaft inside the engine of the FM WORLD 4LZ-6.0P, running in the main bearings and carrying the flywheel and timing gear.
Confirming the correct part
Confirm by part number 4G33TC-060004AZZ, the journal arrangement and the flange and snout.
Reading the old part
Match the journal count, keyway and flange pattern to the engine, and verify the shaft dimensions rather than relying on the tag.
Frequently asked questions
How does the crankshaft turn piston motion into rotation?
The connecting rods attach to offset rod journals, so each piston’s straight stroke rotates the shaft, while the main journals support it in the block and the counterweights balance the forces.
Does a bearing failure always mean a new crankshaft?
No. The journals are measured for wear and cracks; if they remain within tolerance the shaft can be reused with new bearings, but scoring or a crack means it must be repaired or replaced.





