,

Shaft(motor) (New Type) (WHST40-06X)

Part WHST40-06X. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Motor Shaft WHST40-06X (New Type, 222.5 mm, 18 Spline) for FM WORLD

This new-type motor shaft, 222.5 mm long with an 18-tooth spline and 0.9 kg, transmits rotation from the motor through its splined end.

Shaft data

Part numberWHST40-06X
ComponentMotor shaft (new type)
Lower diameter30.5 mm
Upper diameter25 mm
Length222.5 mm
Spline18 teeth
Mass0.9 kg
Set1 piece/set

Transmitting motor rotation

The splined end engages the driven part and carries the motor’s rotation, while the two journal diameters run at their bearing positions.

New-type shaft against the motor

This is the mechanical shaft only, not the motor or its electronic module; the new-type design must be matched by its part number.

Fitting the motor shaft

Fit the shaft into the motor and driven coupling, align the splines, and confirm it seats fully without forcing.

After fitting, turn the assembly and confirm the spline engages smoothly and the shaft runs true.

Spline and journal wear

  • Spline teeth wearing or rounding
  • Bearing journals wearing
  • Shaft bending
  • Surface scoring
  • Shearing or twisting under load
  • Loose fit in the coupling

Ordering checks

Mounting: New-type motor shaft for FM WORLD HST and drive systems.

Confirmation: Quote the WHST40-06X number and confirm the 30.5/25 mm diameters, 222.5 mm length and 18-tooth spline.

Dimensions to match: Match both diameters, the length and the 18 spline teeth to the old shaft.

Motor and module

Buyer questions

What does the 18 refer to?

The spline has 18 teeth that must match the driven coupling exactly.

Why is the part number important?

This is the new-type shaft, so it must be matched by number rather than by rough size alone.

Identification of WHST40-06X before ordering

Choose this shaft when the spline or journals are worn or the shaft is bent; inspect the mating splines and bearings at the same time.

Request a Quote Now