6310 Heavy-Series Ball Bearing for FM WORLD 4LZ-6.0P
The largest of the set, 6310 has a 50 mm bore, 110 mm outer ring and 27 mm width at 1.1 kg, supporting a major shaft of the FM WORLD 4LZ-6.0P under substantial load.
6310 dimensions
| Part number | 6310 |
| Bearing type | Deep groove ball, single row |
| Bore | 50 mm |
| Outer ring | 110 mm |
| Width | 27 mm |
| Weight | 1.1 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
A heavy ring for a 50 mm journal
The 63 heavy series meets the 10 bore code, which multiplies to 50 mm, and the ring grows to 110 mm and 27 mm wide for a heavily loaded journal. Caged balls run in deep hardened tracks that take radial force and axial force both ways while friction stays low.
Bearing fault versus housing alignment
On a heavy shaft, a loose housing or misaligned seat can imitate a bearing fault and will destroy a fresh ring. Confirm the bores are round and aligned before condemning the bearing.
Fitting the large unit
Use a proper sleeve or induction heater to seat the ring on its inner ring, never hammering the outer ring, and fit it square against the shoulder. Journal and housing must be clean and within the manual fits.
No seal suffix appears, so it is an open ring lubricated through the machine’s own arrangement. Protect it from grit and confirm the external seals are sound.
Replacement warning signs
- Heavy rumbling or knocking from spalling tracks
- Noticeable slack on a journal that should be firm
- Vibration and heat under load
- Flaking or pitting on the large raceways
- Grease loss where external sealing has failed
- Brinelling marks after impact or overload
How to confirm and order
Mounting: Fitted to a 50 mm journal of the FM WORLD 4LZ-6.0P and seated in its housing.
Verify: Verify number 6310 and the 50 / 110 / 27 mm measurements.
Dimensions to match: Check the large bore and ring against shaft and housing and inspect the shoulder and width.
Related standard parts
Common questions
Why is 6310 so much larger?
A heavy 63-series ring with a 50 mm bore (the 10 code × 5) gives a 110 mm ring and 27 mm width for a heavily loaded main shaft.
Is it greased for life?
No 2RS suffix appears, so it is open, lubricated through the machine’s own system and protected by external seals.
6310 identification before ordering
Read the stamped number on the large ring and measure the three dimensions. If the marking is worn, send the number and a photo through the quote form for confirmation.





