,

Bevel Gear 15 Teeth (Unloading)

15-tooth unloading bevel gear with keyed bore. Part W2.5-04H-01-01-03. In-stock replacement for the FM WORLD 4LZ-6.0P header and unloading drive.

Bevel Gear 15 Teeth for the FM WORLD 6.0P Unloading Drive

This is a 15-tooth bevel gear in the grain unloading drive, 60 mm outside, 20 mm bore and 35 mm across the hub, weighing 0.35 kg. It drives the right-angle corner that turns the unloading auger, and it only works under load while the tank is being emptied.

Specifications

Part NumberW2.5-04H-01-01-03
Part TypeUnloading bevel gear
Outside Diameter60 mm
Bore20 mm
Hub Height35 mm
Teeth15
Weight0.35 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

Because this gear sees intermittent load rather than continuous running, its wear tends to arrive as shock at engagement rather than as steady pitting: the teeth take the full unloading torque each time the auger clutch takes up, and the backlash opens in a small number of hard cycles. The 20 mm bore and its key carry that shock, so a gear that indexes on a worn key loads the tooth edges instead of the faces. A whine only during unloading, or a knock as the auger engages, points at this corner of the drive.

The two 15-tooth unloading gears

The other 15-tooth gear carries a double bore of 20 and 30 mm and a 36 mm hub; this one has a single 20 mm bore and a 35 mm hub. Same tooth count, different mounting, and the bore is what separates them on the bench.

Fitting notes

Check the keyway and the shaft before fitting, and confirm the contact pattern and backlash against the service manual. Engage the unloading clutch by hand to feel the mesh before the housing is closed, and fill with the specified gear oil.

Before you fit it

Inspect the mating gear and the auger shaft while the housing is open; a worn shaft or a loose mating gear will shorten the new gear’s life even if its own teeth are clean.

Signs it needs replacing

  • Whine heard only while unloading
  • Knock as the unloading clutch engages
  • Edges of the teeth loaded rather than the faces
  • A keyway that has opened under repeated shock

Compatibility and cross reference

Models covered

The 15-tooth bevel gear in the grain unloading drive of the FM WORLD 4LZ-6.0P, single 20 mm bore.

Confirming the right part

Confirm W2.5-04H-01-01-03 on 15 teeth and the single 20 mm bore. The double-bore gear is the other part.

Reading the old part

Count the teeth and measure the bore. The single 20 mm bore identifies this gear among the unloading parts.

Questions we are asked about this part

This gear only runs when I empty the tank. Why is it worn?

Intermittent work does not mean light work: each engagement applies the full unloading torque suddenly, and the teeth and key wear in a small number of hard cycles rather than through steady running.

How do I tell it apart from the other 15-tooth gear?

By the bore. This one has a single 20 mm bore; the other has 20 and 30 mm bores. Counting teeth alone is not enough for this pair.

Related parts