,

Gear Shaft (Unloading Drive)

Gear shaft for the unloading drive. Part W2.5-04H-02-01-00. In-stock replacement for the FM WORLD 4LZ-6.0P header and unloading drive.

Gear Shaft for the FM WORLD 6.0P Unloading Drive

This is the gear shaft of the unloading drive, 235 mm long, with 25, 29 and 23 mm diameters along its length, weighing 1 kg. The pinion is cut directly onto the shaft rather than fitted as a separate gear, so the shaft and the teeth are one part and one replacement decision.

Specifications

Part NumberW2.5-04H-02-01-00
Part TypeGear shaft, integral pinion
Length235 mm
Diameters25 / 29 / 23 mm
Weight1 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

An integral gear shaft has two independent wearing surfaces: the pinion teeth, which wear like any bevel gear under the unloading shock, and the journals, which the bearings turn on. Journal wear is the failure a separate gear does not have: once a bearing has been running on a worn journal, the shaft walks and the mesh loses its contact pattern, and fitting new bearings on a worn journal only returns the same play. A shaft that is noisy only while unloading, or one that shows a scored or polished journal, is replaced rather than repaired.

Gear shaft against a separate bevel gear

The 15-tooth gears are separate parts on a keyed or stepped mount; this part carries the pinion and the bearing journals in one piece. Its three diameters and 235 mm length identify it, and a worn journal means replacing the whole shaft even if the teeth still look clean.

Fitting notes

Inspect every journal and the pinion teeth before fitting, and check the bearings and the housing bores that receive them. The contact pattern, backlash and preload follow the service manual, and the shaft is supported squarely before the cover is closed and the oil filled.

Before you fit it

Replace the bearings with the shaft when the journals are scored or polished, since new bearings cannot hold a true fit on a worn journal.

Signs it needs replacing

  • Scored or polished bearing journals
  • Pitting or shock wear on the integral pinion teeth
  • A contact pattern that will not stay true
  • Knock or whine confined to unloading

Compatibility and cross reference

Models covered

The integral gear shaft in the unloading drive of the FM WORLD 4LZ-6.0P, 235 mm long with three journal diameters.

Confirming the right part

Confirm W2.5-04H-02-01-00 at 235 mm with the 25/29/23 mm journals. The separate bevel gears are different parts.

Reading the old part

Measure the length and the journals, and look for the integral pinion. The one-piece construction identifies it at a glance.

Questions we are asked about this part

The teeth look fine but the shaft is noisy. Why?

The journals may be worn even when the pinion is clean. The bearings turn on those journals, and a worn journal lets the shaft walk and spoils the mesh regardless of the teeth.

Can the shaft be repaired and the bearings reused?

Not reliably. A scored or worn journal is not restored by a new bearing, and the part is a single factory piece, so the shaft is replaced and the bearings are renewed with it.

Related parts