,

Bevel Gear 15 Teeth (Double Bore)

15-tooth unloading bevel gear with double bore. Part W2.5-04H-01-02-02. In-stock replacement for the FM WORLD 4LZ-6.0P header and unloading drive.

Bevel Gear 15 Teeth (Double Bore) for the FM WORLD 6.0P Unloading Drive

This is the second 15-tooth unloading bevel gear, 60 mm outside and 36 mm across the hub, carrying 20 mm and 30 mm bores, and weighing 0.33 kg. The double bore is the feature that identifies it, because it mounts across a stepped shaft in the unloading housing.

Specifications

Part NumberW2.5-04H-01-02-02
Part TypeUnloading bevel gear
Outside Diameter60 mm
Bores20 / 30 mm
Hub Height36 mm
Teeth15
Weight0.33 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

The tooth wear is the same intermittent, shock-driven pattern as the single-bore gear, but the stepped mounting adds a second fit to check. Both bores have to seat true on the stepped shaft; if the 30 mm seat has worn, the gear runs slightly off its axis and the contact pattern walks across the teeth. The two bores also make the gear sensitive to the condition of the shaft shoulders, so the shaft is inspected as carefully as the gear.

Double bore against the single-bore gear

Both gears have 15 teeth and a 60 mm outside diameter, so the only reliable separator is the mounting: 20 and 30 mm here against a single 20 mm bore. Fitting the wrong one leaves the gear either loose on the stepped shaft or unable to seat.

Fitting notes

Check both bores, the shaft shoulders and the key before fitting, then verify the contact pattern and the backlash as the service manual describes. Confirm the gear seats fully against the shoulder and runs true before the housing is closed and filled.

Before you fit it

Because the mounting is stepped, a worn shoulder matters more than a worn key. Inspect the shaft at both diameters before the new gear is fitted.

Signs it needs replacing

  • Shock wear at the tooth edges from engagement
  • A contact pattern that walks across the teeth
  • Wear at the 30 mm seat or the shaft shoulder
  • Knock or whine only during unloading

Compatibility and cross reference

Models covered

The double-bore 15-tooth bevel gear in the unloading housing of the FM WORLD 4LZ-6.0P, on the stepped unloading shaft.

Confirming the right part

Confirm W2.5-04H-01-02-02 on 15 teeth and the 20/30 mm bores. The single-bore gear will not seat on this shaft.

Reading the old part

Count the teeth and measure both bores. The double bore is the identifier even when the part number is unreadable.

Questions we are asked about this part

Why does this gear have two bore sizes?

It mounts on a stepped shaft, and the 30 mm seat locates the gear while the 20 mm section carries the drive. Both seats must be true, or the gear runs off axis.

The two 15-tooth gears look alike. How are they ordered?

By the mounting bore. Measure the shaft and compare: a single 20 mm bore is the other gear, while the double 20/30 bore is this one.

Related parts