,

Charge Pump Gear(Inner) (WHST40-13A-03)

Charge Pump Gear(Inner) (WHST40-13A-03). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Charge Pump Inner Gear WHST40-13A-03 for FM WORLD 6.0P

This is the inner gear of the charge pump for the HST system in the FM WORLD 4LZ-6.0P, 20 mm bore, 42 mm outer diameter, 16 mm wide, weight 0.05 kg. It turns inside the outer gear as the driven member.

Specifications

Part numberWHST40-13A-03
TypeCharge pump inner gear
Bore20 mm
Outer diameter42 mm
Width16 mm
Weight0.05 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
Availabilityin stock, ready to ship

What this part does

This small gear sits on the drive shaft and rolls around the inside of the larger ring. Because it is mounted off-centre, the pockets between its teeth open to admit oil and then close to squeeze it out, which is how the make-up flow is generated. The 20 mm bore locates it on the shaft and the key turns it, and the narrow gap between this gear and the ring is what keeps the oil from leaking straight back, so any loss of that fit is felt as a softer charge pressure.

How the inner gear differs from the ring

This part carries the drive bore and outward-facing teeth and is the moving member; the ring around it is the larger stationary-style housing with inward teeth. One cannot be used in place of the other.

Fitting notes

Slide the gear onto the shaft only after the key is correctly located, then bring the ring and the housing together and verify the turning clearance and that nothing binds, following the manual. A film of clean oil on the parts before assembly helps the first start.

Before you fit it

Look closely at the bore and key seat as well as the tooth flanks, since a worn bore lets the gear run off its true position. When this gear is marked, the ring should be measured at the same time rather than renewed on its own.

Signs this part needs replacing

  • Backlash and a loose fit at the drive bore
  • Key seat rounded so the shaft turns without the gear
  • Charge pump whine under load
  • Aerated oil or a sluggish hydrostatic response when make-up flow falls

Compatibility and cross-reference

Where it fits

Inside the charge pump housing on the hydrostatic transmission of the FM WORLD 4LZ-6.0P, mounted on the drive shaft.

Confirming the correct part

Confirm by part number WHST40-13A-03 and the 20 mm drive bore.

Reading the old part

Identify the inner gear by its drive bore and external teeth, and match it to the outer ring gear.

Frequently asked questions

How does the inner gear pump oil?

It rolls off-centre within the ring so the pockets between its teeth first open to draw oil and then close to expel it, creating the make-up flow.

Is it matched to the outer gear?

Yes. The sealing depends on the narrow gap between the two, so they are measured and renewed as a pair.

Related parts