Chassis Frame (635 kg) for FM WORLD 4LZ-6.0P
This 635 kg welded steel chassis frame, measuring 3150 x 1965 x 967 mm, is the main underframe that carries the engine, threshing section and grain system of the combine.
Chassis frame data
| Drawing number | W2.5DX-03N-01-00 |
| Component | Welded chassis frame |
| Overall dimensions | 3150 x 1965 x 967 mm |
| Mass | 635 kg |
| Machine | FM WORLD 4LZ-6.0P (Ruilong) |
Backbone of the combine
The running gear, engine, threshing assembly and grain tank all bolt to this underframe, so it transfers the weight and working loads down into the tracks or wheels.
Chassis, threshing and rear frames
The chassis frame is the base skeleton, the threshing frame only carries the rotor and concave, and the rear support braces the tail end; each is a separate welded part.
Mounting the underframe
Lower the machine onto the frame, align every mounting face and bracket, and tighten the fasteners following the service manual.
After assembly, check that the frame sits square and that no member is twisted under the weight of the mounted assemblies.
Frame and weld wear
- Cracks opening at weld junctions and high-stress corners
- Mounting holes worn elongated from vibration
- Rust thinning the steel sections
- Bent or twisted members after impact
- Torn or broken brackets
- Fatigue cracks spreading along the welds
Ordering checks
Mounting: Welded chassis underframe of FM WORLD 4LZ-6.0P (Ruilong) harvesters.
Confirmation: Quote the drawing number and confirm the 635 kg frame and the 3150 x 1965 x 967 mm dimensions.
Dimensions to match: Match the overall dimensions and every mounting point to the old underframe.
Related structural frames
Buyer questions
What does the chassis frame carry?
Nearly every major assembly, including the engine, threshing section, grain tank and running gear.
Where does it crack first?
At the weld junctions and mounting corners that take the heaviest repeated loads.
Identification of W2.5DX-03N-01-00 before ordering
Choose this chassis frame when the welds crack, members bend or the mounting holes no longer hold; structural welds should be assessed or replaced by a qualified welder.





