Collar (ZKB60-302-005) for the FM WORLD 6.0P Gearbox
This collar sits on the third-speed shaft in the ZKB85 gearbox and holds Gear III at its working position. It measures 32 mm bore, 40 mm outside and 25 mm long, and weighs 0.1 kg. Its part number shares the 302 group with Gear III (ZKB60-302a-004), which is the clearest sign of where it belongs.
Specifications
| Part Number | ZKB60-302-005 |
|---|---|
| Part Type | Collar, Gear III shaft spacer |
| Bore | 32 mm |
| Outside Diameter | 40 mm |
| Length | 25 mm |
| Weight | 0.1 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
A collar looks like a trivial part until it is missing. Its job is to hold axial position: it takes up the space between the gear and its shoulder so the gear stays where the mesh was designed. Because it is only 25 mm long, a collar that has been replaced with a thinner one, or one that has worn at its end faces, moves the gear along the shaft. The mesh then runs off the centre of the tooth face, which shows up as noise and as a step worn into one end of the teeth.
Collar versus the other collars in this gearbox
This box uses more than one collar and they are not interchangeable. ZKB60-302-005 is 32 mm bore, 40 mm outside and 25 mm long; the other collar in the group, ZKB65-305-008, is 20 mm bore, 60 mm outside and 10 mm long. They differ in all three figures, so a swap is obvious on the bench — but only if someone measures instead of judging by the box label.
Fitting notes
Check both end faces for wear and the bore for fretting before fitting. A collar that has been hammered out often carries a burr on its end face, and that burr is enough to hold the gear off its shoulder. Fit it dry and square, confirm the gear sits against its shoulder rather than on the collar edge, and set end float afterwards according to the service manual.
Before you fit it
Measure the new collar against the old one before fitting. A 25 mm collar that measures 24 mm has lost a millimetre to wear, and that millimetre is exactly what moves the gear off centre.
Signs it needs replacing
- Gear noise that appears after a rebuild, not before
- Step or bright band worn at one end of the gear teeth
- End faces of the collar scored, burred or reduced in length
- Collar that drops onto the shaft with visible play
Compatibility and cross reference
Models covered
The collar shares the 302 group with Gear III (ZKB60-302a-004) on the third-speed shaft of the FM WORLD 4LZ-6.0P gearbox. Same group number means same shaft, not same part.
Confirming the right part
Confirm ZKB60-302-005 on 32 mm bore, 40 mm outside and 25 mm length. The 20 / 60 / 10 mm collar of the same gearbox is a different number and will not space this gear.
Reading the old part
There is usually no readable stamp on a collar. Measure bore 32 mm, outside 40 mm and length 25 mm, and compare the end faces with the new part before fitting.
Questions we are asked about this part
Does the collar set gear end float?
It sets axial position rather than preload: the collar holds the gear against its shoulder, and the end float is then set by the shimming and adjustment described in the service manual. A collar of the wrong length moves the whole mesh.
The old collar looks fine. Can I reuse it?
Only after measuring its length and checking its end faces. A collar that is 1 mm short looks perfect and still moves the gear off the centre of the tooth face, which is where the noise starts.





