,

Header Gear (ZKB85-301a-002)

23-tooth header gear for the ZKB85 gearbox. Part ZKB85-301a-002. In-stock replacement for the FM WORLD 4LZ-6.0P (ZKB85) gearbox.

Header Gear 23T (ZKB85-301a-002) for the FM WORLD 6.0P

The header gear takes drive out of the gearbox and into the header drive train on the FM WORLD 4LZ-6.0P. It is listed as 23 teeth, 80 mm outside diameter, 20 mm bore, 18 mm tall with a 20 mm tooth width, and 0.5 kg.

Specifications

Part NumberZKB85-301a-002
Part TypeHeader gear, 23 teeth
Bore20 mm
Outside Diameter80 mm
Height18 mm
Teeth23
Tooth Width20 mm
Weight0.5 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

This gear is the branch point of the box: it splits drive away from the travel train and sends it forward to the header. Its 20 mm bore and 18 mm face make it a small, lightly built gear by comparison with the 39-tooth gear, but it runs whenever the header is engaged, which on a working day is most of the time. A header that loses speed, surges, or stops under crop load is often this gear rather than the header itself.

Header drive loss and gearbox drive loss look alike

When the header slows down, operators tend to blame the header belt or the knife drive first. The distinction is where the noise comes from: a fault in this gear sits inside the box and is heard there, while a belt or knife fault is heard at the front. Checking the gear means opening the box, so confirm the simple items at the header before stripping the gearbox.

Fitting notes

The 20 mm bore is the critical fit on this gear; a scored shaft will destroy a new one quickly, so inspect and clean the shaft before fitting. Check that the gear meshes with its partner without edge contact, since an 18 mm face has little tolerance for misalignment. Refill and set clearances per the service manual for the ZKB85 gearbox.

Before you fit it

Check the header drive beyond the gearbox before opening the box. A slipping belt and a worn gear produce a similar complaint from the cab.

Signs it needs replacing

  • Header speed drops or surges under crop load
  • Whine from the gearbox side rather than the header when engaged
  • Tooth tips worn thin or chipped on the 20 mm face
  • Bore scored or opened, letting the gear rock on its shaft

Compatibility and cross reference

Models covered

Header drive take-off in the ZKB85 gearbox on the FM WORLD 4LZ-6.0P (Ruilong). ZKB85-301a-002 is the number to match; it is not the travel-train gears beside it.

Confirming the right part

Confirm ZKB85-301a-002 on 23 teeth, 80 mm outside and a 20 mm bore. A 23-tooth gear with a different bore belongs to another position.

Reading the old part

Read the number off the face and count 23 teeth. The 18 mm face makes this gear easy to confuse with a pulley, so check the bore at 20 mm as well.

Questions we are asked about this part

Why does the header still turn but lose speed?

Usually partial engagement damage: the gear still drives but the contact has moved, so it slips under load. Check the teeth and the bore before assuming the header drive is at fault.

Does the 18 mm face mean this gear is weak?

It is a small gear and it is loaded only when the header is engaged. Treated normally it lasts; run against a misaligned partner or with a scored bore, it wears quickly.

Related parts