,

Housing Plate (ZKB65-306-003)

Housing plate for the ZKB85 gearbox. Part ZKB65-306-003. In-stock replacement for the FM WORLD 4LZ-6.0P (ZKB85) gearbox.

Housing Plate (ZKB65-306-003) for the FM WORLD 6.0P

A thin cover plate for the ZKB85 gearbox group on the FM WORLD 4LZ-6.0P: 530 x 350 mm, 1 mm thick, 0.1 kg. It closes an opening in the box rather than carrying load, and it is one of the parts most often left distorted after a repair.

Specifications

Part NumberZKB65-306-003
Part TypeHousing plate (cover plate)
Dimensions530 x 350 x 1 mm
Thickness1 mm
Weight0.1 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

This plate closes an opening on the gearbox housing. Its job is to keep oil in and dust out, and to do that it has to sit flat along its whole edge. At 1 mm thick and 530 x 350 mm across, it is flexible by nature: anything that pulls it down unevenly, or a cover bolted over a distorted edge, leaves a gap that leaks oil onto the track and lets water in when the field is wet.

A leak from this plate and a leak from the gasket

The two are often confused because they are next to each other. A gasket that has hardened or split leaks along a line and usually shows at the joint face. A distorted plate leaks at a point where the edge lifts, often near a bolt, and re-tightening the bolts does not stop it. Cleaning the area and watching where the oil returns separates them.

Fitting notes

Lay the plate flat and check it will sit down along the full edge before fitting, and clean the joint face of old sealant and oil. Tighten progressively around the edge rather than from one end, so the plate is not drawn into a wave. Use the sealing method and the bolt sequence given in the service manual for the gearbox.

Before you fit it

Check the joint face for old sealant build-up and for a step where a previous repair scraped the surface. A plate cannot seal against a stepped face.

Signs it needs replacing

  • Oil leak along the plate edge that returns after tightening
  • Plate bowed or creased, with the edge lifted near a bolt
  • Sealant or gasket extruded and the plate sitting proud
  • Water or chaff entering the box through the opening

Compatibility and cross reference

Models covered

Cover opening on the ZKB85 gearbox group of the FM WORLD 4LZ-6.0P (Ruilong). ZKB65-306-003 is the plate; the brake box gasket is a different number.

Confirming the right part

Confirm ZKB65-306-003 on 530 x 350 mm and 1 mm thickness. A plate of the right length and the wrong thickness will not close the opening properly.

Reading the old part

Close to the plate edge there is a small stamp, and it disappears under paint quickly. Measure 530 x 350 mm and confirm 1 mm thickness, since a thicker plate will not close the opening the same way.

Questions we are asked about this part

Can a bent plate be flattened and reused?

Usually not reliably. This plate is 1 mm thick, so once it has taken a set it tends not to sit flat again, and a plate that lifts at one point leaks no matter how hard the bolts are tightened.

How do I know the leak is the plate and not the gasket?

Clean the joint, run the machine, and watch where oil reappears. A line along the joint points to the gasket; a single wet point near a bolt points to the plate edge lifting.

Related parts